Offer of Sale

Bulletin 4480-T7-US	Karrykrimp 2
Safety Notices

•Read the entire Technical Manual prior to mounting and operating this crimper.

•View the enclosed video or CD prior to operating this crimper.

WARNING - When using this machine, always exercise basic safety precautions, including, but not limited to the following:

1.Use this machine only for its intended purpose: to fabricate Parker hose assemblies.

2.Parker Hanniﬁn will not accept responsibility for any incidental, consequential or special damages of any kind or nature whatsoever that result from any subsequent alterations to any Parkrimp machine. Parker Hanniﬁn disclaims any warranties on items altered after leaving the Parker Hanniﬁn facility.

3.This machine must be properly installed and located in accordance with the installation instructions before it is used.

To minimize the possibility of injury:

1.The power unit must be connected to a grounded, properly rated, protected and sized power-supply circuit to prevent electrical shock and to avoid electrical overload;

2.DO NOT OPERATE OVER MAXIMUM RATED WORKING PRESSURE; AND

3.CHECK FOR SAFE SYSTEM SETUPS.

Make sure that the valve, connecting hoses, etc. are protected from any external source of damage, such as: excessive heat, ﬂame, moving machine parts, sharp edges, falling objects, corrosive chemicals, etc.

IMPORTANT SAFETY NOTICE

THIS INFORMATION IS INTENDED FOR USE BY INDIVIDUALS POSSESSING ADEQUATE BACKGROUNDS OF ELECTRICAL, ELECTRONIC AND MECHANICAL EXPERIENCE. ANY ATTEMPT TO REPAIR THIS MACHINE MAY RESULT IN PERSONAL INJURY AND PROPERTY DAMAGE.

THE MANUFACTURER OR SELLER CANNOT BE RESPONSIBLE FOR THE INTERPRETATION OF THIS

INFORMATION, NOR CAN IT ASSUME ANY LIABILITY IN CONNECTION WITH ITS USE.

DISCONNECT ANY POWER CORD BEFORE SERVICING

IMPORTANT - RECONNECT ALL GROUNDING DEVICES

Parker Safety Guide for Selecting and Using Hose, Tubing, Fittings and Related Accessories

Parker Publication No. 4400-B.1

Revised: May, 2002

WARNING: Failure or improper use of hose, tubing, ﬁttings, assemblies or related accessories (“Products”) can cause death, personal injury and property damage. Pos-

sible consequences of failure or improper selection or improper use of these Products include but are not limited to:

•Fittings thrown off at high speed

•High velocity ﬂuid discharge

•Explosion or burning of conveyed ﬂuid.

•Electrocution from high voltage electric power lines.

•Contact with suddenly moving or falling objects that are controlled by the conveyed ﬂuid.

•Injections by high-pressure ﬂuid discharge.

•Dangerously whipping Hose.

•Contact with conveyed ﬂuids that may be hot, cold, toxic or otherwise injurious.

•Sparking or explosion caused by static electricity buildup or other sources of electricity.

•Sparking or explosion while spraying paint or ﬂammable liquids.

•Injuries resulting from inhalation, ingestion or exposure to ﬂuids.

Before selecting or using any of these Products, it is important that you read and follow the instructions below. Only Hose from Parker’s Stratoﬂex Products Division is ap-

proved for in ﬂight aerospace applications, and no other Hose can be used for such in ﬂight applications.

The items in this document are hereby offered for sale by Parker Hanniﬁn Corporation, its subsidiaries or its authorized distributors. This offer and its acceptance are governed by the provisions stated in the "Offer of Sale".

2	Parker Hanniﬁn Corporation
	Hose Products Division

Wickliffe, OH