RCA TOCOM 1616332A manual Using Automatic Code Search, Using Direct Entry

Page 13

Using the Remote Control

Using Automatic Code Search

The following instructions can be used to program the remote to operate each of your components. If you want to stop the automatic code search without programming any of your components, press CLEAR until the indicator light on the remote turns off.

1.Turn on the component you want to operate (VCR or DVD player)

2.Press and hold the component button you want to program (VCR or DVD). While holding the component button, press and hold ON¥OFF until the indicator light on the remote turns on, then release both buttons.

3.Point the remote at the component. Press and release PLAY (the indicator light on the remote flashes).

The remote is searching for the correct code to program. When the indicator stops flashing (after about 5 seconds), press PLAY again to tell the remote to search the next set of codes.

Continue pressing PLAY until the component turns off or the indicator light on the remote turns off. If the indicator light turns off, then all the codes for that particular component have been tested once. If the component does not turn off, then the remote canÕt be programmed to operate that component.

Note: Each time you press PLAY, the remote sends about 10 sets of codes. Therefore, you might have to press the PLAY button up to 20 times.

If the component you want to operate does turn off:

1.Press and release REVERSE, then wait 2 seconds. Repeat this step until the device turns back ON.

2.To finish, press and hold STOP until the indicator on the remote turns off.

Using Direct Entry

1.Turn on the component to be programmed.

2.Look up the brand and code number(s) for the component on the code list in this section.

3.Press and hold the component button you want to program on the remote.

4.Enter the code from the remote control code list on the following pages. If the indicator flashes, you have either entered an invalid code or the button isnÕt programmable.

5.Release the component button.

6.Point the remote at the component. Press ON¥OFF to see if the component responds to the command. If it doesnÕt, try pressing the component button and then ON¥OFF again.

¥If you get no response, repeat these steps using the next code listed for your brand, until the component responds to the remote commands.

¥If you try all the codes for your component brand and none work, try the automatic code search method. If automatic code search doesnÕt find the code, the remote is not compatible with your component.

Chapter 2

Graphics contained within this publication are for representation only.

11

Image 13
Contents Changing Entertainment. Again Television Users GuideProduct Registration Important InformationProduct Information Table of Contents Table of Contents Chapter Things to Consider Before You ConnectConnect your DVD Player to your TV Connections & SetupConnect your TV to your VCR Make sure cable or antenna is connected to your VCRMono Audio Explanation of JacksFront Input Jacks Front of Your TVFront Panel Buttons Complete the Initial Setup How to Use the Remote Control to Complete the Initial SetupPlug in the TV Put batteries in the remoteComplete Auto Channel Search Indicator Button Descriptions for TV ModeButton Descriptions for DVD and VCR Modes Using the Input Button Using the Remote ControlProgramming the Remote to Operate Other Components Find Out If You Need to Program the RemoteUsing Direct Entry Using Automatic Code SearchHow to Use the Remote After You’ve Programmed It Remote Control CodesVCR Codes VCR Codes How to Set Up the Auto Tuning Feature Why You Should Use the Auto Tuning FeatureChannel Banner Parental Controls and V-Chip Using the TV’s FeaturesUSA V-Chip Rating System How V-Chip WorksCanadian English V-Chip Rating System Canadian French V-Chip Rating System V-Chip Rating Screen USA V-Chip TV Rating LimitContent Themes Blocking Specific Content ThemesHierarchy of Age-Based Ratings Blocking Age-Based RatingsBlocking Canadian V-Chip Ratings Viewing Specific Content ThemesChip Movie Rating Limit Blocking Movie RatingsChip Exempt Program Block Change PasswordChip Active Front Panel LockPicture Menu Sound MenuSetup Menu Using the TV’s Menu SystemTime Menu Parental Control MenuTroubleshooting Other Information Limited Warranty Care and CleaningWhat your warranty does not cover HOW to Order Tocom 1616332A Thomson IncTéléviseur Guide de l’utilisateur Enregistrement du produit Information importanteInformation sur le produit Table des matires Table des matires ProtŽgez vos composants contre la surchauffe PrŽvenez les surtensionsUtilisez un Žclairage indirect TŽlŽviseur + lecteur DVD + magnŽtoscope Connexions et rŽglageConnectez votre lecteur DVD à votre téléviseur Connectez votre téléviseur à votre magnétoscopeExplication des prises Prises dÕentrŽe avant Avant du tŽlŽviseurBoutons du panneau avant ExŽcution de lÕinstallation initiale Insertion des piles dans la tŽlŽcommandeBranchement du tŽlŽviseur Mise en marche du tŽlŽviseurRecherche automatique complte de canaux Description des touches pour les modes DVD et VCR Description des touches pour le mode TVVoyant Comment savoir si vous devez programmer la tŽlŽcommande Utilisation de la tŽlŽcommandeProgrammation de la tŽlŽcommande Utilisation de la touche InputUtilisation de lÕentrŽe directe Utilisation de la recherche automatique du codeUtilisation de la tŽlŽcommande une fois programmŽe Codes de tŽlŽcommandeCodes pour magnŽtoscopes Programmable pour la touche DVD Codes pour magnŽtoscopes suitePourquoi utiliser la fonction de syntonisation automatique Bannire de canalRŽglage de la fonction de syntonisation automatique Contrle parental et V-chip Utilisation des fonctions du tŽlŽviseurSystme de filtrage TV pour les ƒ-U Fonctionnement du V-chipSystme de filtrage TV pour le Canada anglais Systme de filtrage TV pour le Canada franais LÕŽcran de Filtrage TV Filtrage TV pour les ƒ-UHiŽrarchie des catŽgories dÕ‰ge Blocage de thmes particuliersBlocage des catŽgories dÕ‰ge Visionnement des catŽgories dÕ‰geBlocage pour le filtrage canadien Visionnement de thmes particuliersFiltrage des films V-chip Blocage des Filtrage filmsChip actif Blocage des Žmissions sans codeVerrouillage du panneau avant Changement de mot de passeMenu Image Menu SonUtilisation du systme de menus du tŽlŽviseur Menu InstallationMenu Horloge Menu Contrle parentalDŽpannage Autres informations Garantie limitŽe Entretien et nettoyageEnregistrement du produit Limitation de la garantie Ce que ne couvre pas votre garantieLÕeffet des lois provinciales sur cette garantie Description De rŽf. Prix Télécommande CÕestThomson Inc North Meridian Street Indianapolis,