Mitsubishi Electronics LT-2220/LT-3020 Remote Control Functions Channel Selection, Sleep Timer

Remote Control Functions: Channel Selection, Sleep Timer

Channel Selection

Enter three numbers ( ex. for channel 2, press 002).

or

Press the channel number and ENT (ex. for channel 2, press 2, then ENT).

or

Enter the channel number and wait four seconds (without pressing ENT). The TV will change automatically.

Note: Use the CANCEL button for digital subchannel (-) selection in the CABLE/DBS/DTV layer.

��� ��	�������	����	�����
	��� ������	������	�������

Figure 3 . Sleep button on remote control

Sleep:  min.

Figure 4. On-screen display for sleep timer

26

LCD Monitor 5 8 03.indd 26

Sleep Timer

(Figures 3 & 4)

Setting the Sleep Timer:

Press SLEEP on the remote control.

A message indicating the length of time the sleep timer is to be set appears on the TV screen.

Each press of SLEEP will increase the time displayed by 30 minutes, until the maximum value of 120 minutes is reached.

After 5 seconds of inactivity, the message will disappear.

Press SLEEP to view the remaining time before the timer turns the TV off.

Canceling the Sleep Timer:

Press the SLEEP button to display the on-screen message.

Press SLEEP repeatedly until OFF is displayed. After 5 seconds of inactivity, the message will disappear.

5/8/2003, 3:02 PM