Mitsubishi Electronics LT-46148, LT-40148 manual Setting Up NetCommand Control of an A/V Receiver

606. NetCommand IR Control

Setting Up NetCommand Control of an A/V Receiver

Several types of A/V receiver control can be set up using the Inputs > AVR menu, shown on the following pages.

•Controlling power and volume is described on this page.

•Automatic audio switching, suitable for most equip- ment setups, is described under “A/V Receiver Control: Automatic Audio Switching” on the oppo- site page.

•Automatic audio and video switching can be set up If your A/V receiver has an HDMI output. You can send audio and video from multiple devices to the A/V receiver and then through a single cable to the TV. See “A/V Receiver Control: Automatic Audio and Video Switching via HDMI,” page 63.

Note: To set up control of other device types, see “Initial NetCommand Setup for Most Devices,” page 56.

A/V Receiver Control: Power and Volume

Perform this setup to operate the A/V receiver’s power and volume functions with the TV’s remote control.

To perform this setup you need:

•The remote controls for both the TV and the A/V receiver.

•The IR emitter cable supplied with the TV.

Before You Begin

1.Connect your A/V receiver to the TV and any addi- tional devices. See chapter 3, “TV Connections,” for suggestions.

2.Connect the IR emitter cable to the TV and position the IR emitter where it can send signals to the A/V receiver. See “IR Emitter Placement,” page 55.

3.Set the TV’s remote control slide switch to the TV position and power on the TV if not already on.

Setup to Control A/V Receiver Power and Volume

1.Open the AVR screen in one of two ways:

•If using the Auto Output or Auto Input Sensing screen for the A/V receiver, highlight the Learn icon and press ENTER to open the AVR screen.

•If performing NetCommand setup at any time after the A/V receiver has been recognized through Auto Output/Auto Input Sensing:

Press MENU, highlight Inputs, and highlight AVR to open the AVR screen.

2.The first function highlighted in the AVR screen is always Power On. Aim the TV’s remote control at the TV and press ENTER to begin learning for Power On.

AVR screen. Perform NetCommand IR “learning” for A/V receiver power and volume keys.

3.When the Power On text starts flashing, aim the A/V receiver’s remote control at the TV and press and hold the POWER or POWER ON key until a check mark appears next to Power On.

•If the text stops flashing before the check mark appears, repeat this step.

•To remove the key from NetCommand control, press the CANCEL key while the key name is highlighted.

4. Press the key on the TV’s remote control to highlight other keys in the list. Repeat steps 2 and 3 for each addi- tional function you wish to control through NetCommand.

5.If the A/V receiver has a separate POWER OFF key,

press on the TV’s remote to highlight Power Off. Repeat steps 2 and 3 to “learn” the POWER OFF key.

6.When finished “learning” the power and volume keys, either press EXIT to watch TV or leave the AVR screen open to continue with NetCommand setup to control switching of A/V receiver inputs.

IMPORTANT

To hear audio sent from the TV to the A/V receiver, you must have:

•Physically connected the TV to the A/V receiver.

•Assigned, if needed, the name AVR if using an HDMI A/V receiver.

•Selected the A/V receiver as the audio source.

Press AUDIO, then to show the Speakers option, then to select the A/V Receiver.

•“Learned” the IR codes for the A/V receiver inputs.

•Assigned the TV’s audio output to the correct input in the NetCommand A/V Receiver Learn screen.