Mitsubishi Electronics WD-62530 Battery Installation, FAV Favorite Channels, Sleep Timer, Care

Chapter 3. TV Operation 31

Remote Control, continued

	1
	2		5
	3
	4
			6
	7		11
	8		12
	9
	10		13
			14
			15
			18
	16		19
	17		20
23	24	25	21
26	27	28
	22

Figure 1. Remote Control Overview

Battery Installation

1.Remove the remote control’s back cover by gently pressing in the tab and lifting off the cover.

2.Load the batteries, making sure the polarities (+) and (-) are correct. For best results, insert the negative (-) end first.

3.Snap the cover back in place.

FAV (Favorite Channels)

For use of the FAV feature with the remote control, see chapter 5, “TV Menu Setting,” and the explanation of the Channel menu.

1

2

Figure 2. The remote control requires two AA alkaline batteries.

Sleep Timer

Setting the Sleep Timer

1.Press SLEEP on the remote control.

2.Press SLEEP additional times to increase the time in 30- minute increments up to the maximum of 120 minutes.

3.Wait five seconds without pressing any buttons for the message to disappear or press EXIT.

4.Press SLEEP to view the time remaining before the sleep timer turns off the TV or press EXIT.

Cancelling the Sleep Timer

1.Press SLEEP to display the on-screen message.

2.Press SLEEP repeatedly until OFF is displayed.

Note: After five seconds of inactivity, the message box will disappear or press EXIT.

Care

For Best Results from the Remote Control:

•Use only alkaline batteries.

•Be within 20 feet of the equipment.

•Do not press two or more buttons at the same time unless instructed to do so.

•Do not allow unit to get wet or become heated.

•Avoid dropping on hard surfaces.

•Do not use harsh chemicals to clean. Use only a soft, lightly moistened cloth.

•Do not mix old and new batteries.

•Do not heat, take apart, or throw batteries into fire.

Resetting the Remote Control

If the slide switch is set to TV and the TV does not respond properly, do the following to reset the remote control.

1.Press and hold POWER for several seconds until the button blinks twice and goes off.

2.Release the POWER button.

3.Press keys 0 0 9 3 5 and the POWER button will blink twice when you finish entering the code. While enter- ing the code, pause for a moment between each key press to ensure it is recognized.