Mitsubishi Electronics SeriesLT-40151 manual Start

4. TV Menus 49

Initial, continued

Sound Projector

For full setup instructions, see page 34.

Basic Screen

	Mode	Auto	START	Perform Auto setup using the supplied calibration
	(153, 249 series)			microphone. See page 36.
SoundPro
		Manual	Custom	To perform manual setup, see page 34.
				Note: Do not perform manual adjustments after
				running Auto setup. Doing so will erase all settings
				created during Auto setup.
	TV Location	Center, Left, L		Highlight the item that best describes the TV’s loca-
		Corner, Right, R		tion relative to the wall. Required for Manual setup.
		Corner
	TV Wall Length	[Enter digits]		Press	to change the number or enter digits.
	(in feet)			Required for Manual setup.
	Other Wall	[Enter digits]		Press	to change the number or enter digits.
	Length (in feet)			Required for Manual setup.
	TV to Sofa	[Enter digits]		Press	to change the number or enter digits.
	(in feet)			Enter the distance from the TV to the primary seating
				area. Required for Manual setup.
	Custom	After defining the room layout, highlight Custom and press ENTER. Use this
	(all models)	option to fine-tune Sound Projector to your unique room layout. See details
		on page 35.

Adjustments in the Custom Menu

Left Beam Angle

Right Beam Angle

Center Beam Angle

Left Surround Beam

Angle

Right Surround Beam

Angle

Left Level

Right Level

Center Level

Left Surround Level

Right Surround Level

•Press to select an audio beam; colors of the adjusters correspond to audio beams in the on- screen diagram.

•Press to redirect the audio beam or change the sound level.

•To reset these adjustments, see “Resetting Angle and Level Values in the Custom Menu,” page 35.

Controls in the SoundPro > Custom menu adjust the direction and focus of the TV’s sound output.

At extreme beam angles, adjustment may be limited and the image on screen may not accurately represent the sound beams.