Mitsubishi Electronics 154 Series, 265 Series Programming the Remote Control, Code Verification

74Appendices

Appendix A: Programming the Remote Control, continued

Programming the Remote Control

1.Press one of the upper buttons on the remote control to change to the correct mode for the product you want to control. Refer to the table below. Only one of each device type can be con- trolled in each mode.

Mode	Affected Device
Cab/SAT	Cable Box
	DTV Receiver
	Satellite Receiver
VCR	VCR
	DVR
	DVD Player/Recorder
DVD	DVD Player/Recorder
	DVR
	VCR
Audio	A/V Receiver
	Audio Amplifier
	CD Player

2.Press and hold POWER on the remote control for several seconds until the key blinks twice and goes off.

3.Release the POWER key.

4.Enter the first five-digit code listed for your equip- ment in the reference tables that follow.

If you need to start over or wish to exit programming mode, temporarily change to a different device mode.

5.Point the remote control at the equipment and press POWER. If the product has no power on/off

function, press a different key, such as (Play),

(Stop), VOLUME UP, or MUTE.

•If the equipment responds, the remote control is properly programmed.

•If the equipment does not respond, repeat steps 4 and 5 with the next five-digit code listed for your equipment.

6.Once you have found the correct code, write it in the space below for future reference.

Mode	Device Type	Code
CABLE/SAT
VCR
DVD
AUDIO

IMPORTANT

You may need to reprogram the remote control after changing the batteries. Record the codes for each mode in the space provided to make this faster.

Code Verification

To determine the code programmed for any mode:

1.Set the mode to the one you wish to verify.

2.Press and hold POWER on the remote control for several seconds until the key blinks twice and goes off.

3.Press keys 9 9 0

4.Press 1 and count the blinks of the power key. Write down the number of blinks as the first digit of the code.

5.Repeat step 4 for the second, third, fourth, and fifth digits of the code.

Audio Lock: Universal A/V Receiver Control

With Audio Lock enabled, the remote control oper- ates volume and mute on an A/V receiver in all control modes. Activate Audio Lock if you always use an A/V receiver with your TV and other A/V equipment.

1.Program AUDIO mode for your A/V receiver as described in “Programming the Remote Control” on this page.

2.With the remote control in AUDIO mode, hold POWER on the remote control for several seconds until the key blinks twice and goes off.

3.Press keys 9 9 3 ENTER

The POWER key will blink twice to indicate Audio Lock is active.

To Reset the Remote Control to Operate Volume and Mute for the TV Speakers

1.Press and hold POWER for several seconds until it blinks twice and goes off.

2.Press keys 9 9 3 VOLUME UP.

The POWER key will blink four times to indicate Audio Lock has cleared.

DownloadedFor assistanceFrom TV-Manualcall.com1(800)Manuals 332-2119