Mitsubishi Electronics WD-73837 manual Stand Requirement, TV Model Stand Model

Page 2

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user of the presence of uninsulated “dangerous voltage” within the product’s

enclosure that may be of sufficient magnitude to consti- tute a risk of electric shock to persons.

The exclamation point within an equilat- eral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.

MAINS DISCONNECTION: The mains plug is used as the disconnect device. The disconnect device shall remain readily operable.

Stand Requirement

CAUTION: Use these Mitsubishi TV models only with the Mitsubishi stand models shown here. Other stands can result in instability and possibly cause injury.

TV Model

Stand Model

 

 

WD-60C9, WD-65C9

 

WD-60737, WD-65737

MB-S60/65

WD-65837

 

 

 

WD-73C9

 

WD-73737

MB-S73

WD-73837

 

 

 

82-inch TVs: Mitsubishi does not design, manufacture, or sell matching bases for 82-inch televisions (WD-82737, WD-82837). When selecting a stand, base, or other fur- niture to support the TV, please make sure it is designed with the appropriate dimensions for stability and to support the TV’s total weight as well as the weight of any additional equipment you plan to store.

TV WEIGHT: This TV is heavy! Exercise extreme care when lifting or moving it. Lift or move the TV with a minimum of two adults. To prevent damage to the TV, avoid jarring or moving it while it is turned on. Always power off your TV, unplug the power cord, and discon- nect all cables before moving it.

WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.

WARNING: This product contains chemicals known to the State of California to cause cancer and/or birth defects or other reproductive harm.

FCC Declaration of Conformity

Product:

Projection Television Receiver

Models:

WD-60C9, WD-65C9, WD-73C9

 

WD-60737, WD-65737, WD-73737,

 

WD-82737

 

WD-65837, WD-73837, WD-82837

Responsible

Mitsubishi Digital Electronics

Party:

America, Inc.

 

9351 Jeronimo Road

 

Irvine, CA 92618-1904

Telephone:

(800) 332-2119

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal- lation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communica- tions. However, there is no guarantee that interfer- ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

»» Reorient or relocate the receiving antenna.

»» Increase the separation between the equip- ment and the receiver.

»» Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

»» Consult the dealer or an experienced radio/ TV technician for help.

Changes or modifications not expressly approved by Mitsubishi could cause harmful interference and would void the user’s authority to operate this equipment.

ENERGY STAR® Compliance

This TV meets ENERGY STAR® efficiency standards in all operating modes.

Image 2
Contents C9 Series Stand Requirement TV Model Stand ModelContents Outdoor Antenna Grounding Replacement PartsInstallation Notes Remote Control Hdmi TV Connector Panel DiagramsConnector Performance HDMI-to-DVIConnecting with Composite Video Connecting DevicesConnecting with Hdmi or DVI Connecting with Component Video Connecting A/V Receiver for TV Video and Audio Output Connecting Antenna or Cable without a BoxConnecting A/V Receiver for TV’s Audio Output Recording to a Device from Antenna or Cable without a BoxDevice Type and Activity Customizing Device SetupAuto Device Discovery Feature Selecting a Source to WatchMemorizing Channels TV Channel SetupUsing ChannelView ChannelView Channel ListingsPicture Mode Video Noise Sharp Edge Deep Field Imager AdjustPicture and Sound Settings TV MenusSAP PerfecTint Adjust Mode and pressPerfectColor AdvancedCaptions Closed-Caption SettingsSetup of TV Features InitialInitial Inputs Input ManagementLock Controlling TV UsagePlaylist Once, Twice, or Continuous EnterFor automatic advance only Watching 3D Video Initial Setup3D Video To Watch Regular non-3D VideoGeneral TV Operation Symptom RemarksTV Channels Symptom Remarks TV Power On/Off Symptom RemarksPicture Symptom Remarks Sound Symptom Remarks Lamp-Substitution Alert Lamp Part Number 915B403001Lamp Installing the New Lamp Cartridge Lamp-Cartridge ReplacementLamp-Cartridge Filter Cleaning Removing the Old Lamp CartridgeMitsubishi DLP Projection Television Limited Warranty Warranty27 Trademark and License InformationMitsubishi TV Software END-USER License Agreement for Embedded SoftwarePage MDEAservice@mdea.com System Reset
Related manuals
Manual 69 pages 19 Kb