Mitsubishi Electronics WD-73837 manual Lamp Part Number 915B403001, Lamp-Substitution Alert

Page 24
CAUTION
BURN DANGER! HOT SURFACES INSIDE!
Touch lamp cartridge handle only. Do not touch lamp or lamp car- tridge housing. Keep lamp cartridge horizontal during removal. Do not tilt as glass may come out and cause injury. Replace lamp car- tridge only with the same part number 915B403001.

24

Lamp-Cartridge Replacement and Cleaning

CAUTION: If the television is on, press POWER to turn it off. Unplug the television and allow it to cool for at least one hour before attempting to replace the lamp cartridge.

Lamp

The light source for this television is a lamp, which is part of a lamp cartridge assembly. The life of the lamp can vary, based on the lamp itself, the air temperature around the TV while it is operating, the selected lamp mode, and your viewing patterns. Warmer air or poor ventilation shorten the lamp life, as does use of the Bright lamp mode and turning the television on and off

frequently. Mitsubishi warrants the lamp for one (1) year from the date of original TV purchase at retail.

To Order a New Lamp

To Receive a Replacement Lamp Under Warranty

Call (800) 553-7278. Please have model number, serial number, and TV purchase date available.

Important: All lamps replaced under warranty must be returned to Mitsubishi where they will be inspected for defect verification.

To Purchase a Replacement Lamp After Warranty

Visit our website at www.mitsuparts.com or call (800) 553-7278. Order the following:

WARNING

THE ACCESS PANEL IS PROVIDED WITH AN INTERLOCK TO REDUCE THE RISK OF EXCESSIVE ULTRAVIOLET RADIATION. DO NOT DEFEAT ITS PURPOSE OR ATTEMPT TO SERVICE WITHOUT REMOVING PANEL COMPLETELY.

Lamp Part Number 915B403001

Lamp-Substitution Alert

MDEA recommends that you use only genuine Replacement Lamp Assemblies purchased directly from Mitsubishi or a Mitsubishi Authorized Dealer or Mitsubishi Authorized Service Center. MDEA advises that replacement lamps obtained separately from the Lamp Cartridge and/or Lamp Assemblies obtained from unauthorized sellers may be incorrect for your television, may not fit or perform properly and may even damage your television. MDEA can not be responsible for the performance, reliability or safety of any replacement lamps that are obtained from unauthorized sources.

WARNING

Do not remove the lamp cartridge immediately after turning off the television. You may get burned because the lamp is very hot. Allow the television to cool for at least one hour before replacing the lamp cartridge.

Do not remove the lamp cartridge except when replacing it. Careless treatment can result in injury or fire.

Do not touch the lamp glass element. It may be very hot and break, causing injuries or burns.

Be sure not to insert any metal or flammable object into the lamp cartridge opening, as it may cause fire or electrical shock. If a foreign object is inserted into the opening, unplug the AC cord of the TV and contact your dealer for service.

Install the lamp cartridge securely. Failure to do so may cause a fire.

Do not touch the lamp glass elements. Oils from your fingers may cause premature lamp failure.

THE LAMP INSIDE THIS PRODUCT CONTAINS MERCURY AND MUST BE RECYCLED OR

Hg = MERCURY DISPOSED OF ACCORDING TO LOCAL, STATE OR FEDERAL LAWS. For disposal or recy- cling information, please contact your local authorities or the Electronic Industries Alliance at

www.eiae.org

Image 24
Contents C9 Series Stand Requirement TV Model Stand ModelContents Replacement Parts Installation NotesOutdoor Antenna Grounding Remote Control TV Connector Panel Diagrams Connector PerformanceHdmi HDMI-to-DVIConnecting Devices Connecting with Hdmi or DVI Connecting with Component VideoConnecting with Composite Video Connecting Antenna or Cable without a Box Connecting A/V Receiver for TV’s Audio OutputConnecting A/V Receiver for TV Video and Audio Output Recording to a Device from Antenna or Cable without a BoxCustomizing Device Setup Auto Device Discovery FeatureDevice Type and Activity Selecting a Source to WatchTV Channel Setup Using ChannelViewMemorizing Channels ChannelView Channel ListingsAdjust Picture and Sound SettingsPicture Mode Video Noise Sharp Edge Deep Field Imager TV MenusSAP Adjust Mode and press PerfectColorPerfecTint AdvancedClosed-Caption Settings Setup of TV FeaturesCaptions InitialInitial Inputs Input ManagementLock Controlling TV UsageEnter For automatic advance onlyPlaylist Once, Twice, or Continuous Initial Setup 3D VideoWatching 3D Video To Watch Regular non-3D VideoGeneral TV Operation Symptom RemarksTV Channels Symptom Remarks TV Power On/Off Symptom RemarksPicture Symptom Remarks Sound Symptom Remarks Lamp Part Number 915B403001 LampLamp-Substitution Alert Lamp-Cartridge Replacement Lamp-Cartridge Filter CleaningInstalling the New Lamp Cartridge Removing the Old Lamp CartridgeMitsubishi DLP Projection Television Limited Warranty Warranty27 Trademark and License InformationMitsubishi TV Software END-USER License Agreement for Embedded SoftwarePage MDEAservice@mdea.com System Reset
Related manuals
Manual 69 pages 19 Kb