Mitsubishi Electronics PD-4225S manual Installing the Plasma TV on the Stand, Preparations

Page 12

Installation

Installing the Plasma TV on the Stand

Preparations

1.Unpack the plasma TV.

1.Open the top of the cardboard in which the plasma TV is packed and remove the three pieces of styrofoam.

2.Pull off the cardboard from the top protective sheet.

Styrofoam

Protective sheet

2. Lay the plasma TV down.

Place the protective sheet in which the plasma TV was wrapped on a strong and sturdy table or stand larger than the plasma TV. Lay the plasma TV on the protective sheet face down. Placing pressure on the glass surface on the front of the plasma TV could damage it.

3.Remove the stand from the box.

4.Insert the stand into the mounting legs of

the plasma TV and fasten it.

Use four of the included display mounting screws to fasten the TV to the stand.

For proper ventilation, allow a clearance of 4” on each side and the top, 2.36” on the bottom, and 2” from the wall.

 

4 inches

2 inches

 

 

4 inches

 

4 inches

 

 

2.36 inches

CAUTION:

Tighten the screws immediately after placing the TV on the stand. If not, the TV could tip over, resulting in injury.

12 Plasma TV

Image 12
Contents Owner’s Guide Regulatory Information Safety Instructions Safety Instructions Precautions Important InformationImportant Information Important Information Cleaning Safeguards Cleaning Your Plasma TVCleaning the cabinet of your Plasma TV General Cleaning WarningsWhat is a Plasma Display Panel PDP? IntroductionContents Installation Factory InstalledInstalling the Plasma TV on the Stand PreparationsWall Mount Installation Matching Speaker Installation Volume D and E ControlsChannel D and E Connection Options Front Connection PanelTo Display Factory Connected To Tuner Factory ConnectedRemote Control Functions Care and Operation Operating the Remote ControlInstalling Batteries OperationRemote Control Functions Overview of the TV Layer Buttons OverviewUse of the Remote Control with Other A/V Products DVD Player Codes Remote Control Functions Special Functions Remote Control Functions Operation of PIPExternal Equipment Connections Antenna ConnectionVCR Setup Cable TV SetupVideo Rear External A/V Source Setup DVD SetupDTV Setup Component Input portsMonitor Out Setup PC SetupHD-5000/MONITORLINK Setup Resolution Horizontal VerticalOperation Turning on the TVMenu Language Selection Fine Tuning Adjustment Channel Menu OptionsMemorizing the Channels with Auto Program Memorizing the Channels with Manual ProgramAuto Color Temperature Control Manual Color Temperature Control Programmable optionPicture Menu Options Auto Picture ControlAudio Mode Stereo/SAP Broadcasts SetupSound Menu Options Level SoundTimer Menu Options Auto Clock SetupManual Clock Setup On/Off Timer SetupSleep Timer Auto OffLow Power Special Menu OptionsButton Lock Long LifeSpecial Menu Options Closed Captions Caption/Text CaptionsAuto Adjustment Setting Picture FormatScreen Menu Options Picture Size ZoomAdjusting Horizontal/ Vertical Position Manual Adjust RGB-PC mode onlyInitializing Reset to original factory value Selecting Wide VGA mode RGB-PC, DVI-PC mode only Screen Menu OptionsPIP Picture-In-Picture Feature Sub Picture Size Adjustment Lock Menu Options Lock Setup Setting lock on/offSet password External Control Device Setup MONITORLINK/RS-232C SetupType of Connector D-Sub 9-Pin Male RS-232C ConfigurationsTroubleshooting Checklist Speakers ButtonScreen Product Specifications Operating Temperature RangeAppendix a Remote Control Programming Codes ReceiversDBS/DTV Plasma TV Mitsubishi Plasma Display Panel Limited Warranty To Obtain Warranty Service3828VA0361Q c