Mitsubishi Electronics PD-4225S manual Use of the Remote Control with Other A/V Products

Use of the Remote Control with Other A/V Products

Programming the Remote Control to Use with Other Brands of Audio and Video Products:

(Figures 1-3 this page, figures 4-5 following page)

1.Move the slide switch at the top of the remote to the product you want to control.

2.Press and hold the POWER button on the remote control.

3.Enter the first three digit code listed for your equip- ment, and then release the POWER button on the remote control.

4.Point the remote control to the equipment and press the POWER button.

Note: If the equipment responds, the remote control is properly programmed to operate the equipment. If the equipment does not respond, repeat steps 2- 4 with the next three digit code listed in step 3 for your equipment.

IMPORTANT

When set to TV, the PLAY, STOP, REW/REV, and FF/FWD buttons will operate the VCR after the VCR codes have been properly programmed into the remote control.

	CABLE/DBS/DTV			VCR		DVD
	TV							AUDIO	2.POWER
1.
3.			Cable Box Codes
	Cable box brand			Code to enter:					If your
									cable box
	General Instruments/			119, 120, 121, 122,123,
	Jerrold			124					code is not
									listed here,
	Motorola			125, 126, 127
									please see
	Oak			139, 137, 102
									page 48
	Pioneer			101, 116
									for a
	Scientific Atlanta			112, 113
									complete
	Zenith			117, 100
									listing.
	To reset to default code, enter 000
Figure 1. Programming the remote to control your cable box.
	CABLE/DBS/DTV		VCR		DVD
	TV						AUDIO		2.POWER
1.
3.		Satellite			Receiver Codes
	Satellite brand				Code to enter:				If your
	Mitsubishi DTV - DBS				006				satellite
	DishNetwork				175				receiver
	Hughes - DBS				173				code is not
									listed here,
	Panasonic - DBS				174
									please see
	RCA - DBS				176
									page 49 for
	Sony - DBS				177
									a complete
	Toshiba-DBS				170, 173, 189, 190, 191
									listing.
	To reset to default code, enter 000

Figure 2. Programming the remote to control your satellite receiver.

	CABLE/DBS/DTV	VCR		DVD
	TV				AUDIO	2.POWER
1.
3.			VCR Codes
	VCR brand		Code to enter:			If your
	Mitsubishi		001, 002			VCR
	Hitachi		020, 043, 065			code is not
						listed here,
	JVC		030, 054
						please see
	Philips / Magnavox		043, 044, 051
						page 49
	Panasonic		041, 042, 043
						for a
	RCA		020, 053, 065
						complete
	Sony		048, 049, 050
						listing.
	Toshiba		021
	To reset to default code, enter 000

Figure 3. Programming the remote to control your VCR.

20 Plasma TV