Mitsubishi Electronics 164 Series Sleep Timer, Photos and Moving Video As Composite Video, Enter

Camera Images and Music Files continued

Photos and Moving Video

as Composite Video

Connect the camera to the TV using a composite video cable and control the slide show or movie through the camera. The display resolution will be standard-defini- tion (480i).

1.Refer to the owner’s manual supplied with the camera for instructions needed for this setup.

2.Set the camera’s output signal type to NTSC and put the camera into playback mode.

3.With the camera still turned on, connect your digital camera’s composite video cable (usually yellow) to the TV’s Y/VIDEO jack. To hear audio, connect the camera’s audio output cable to the AUDIO L jack.

Camera connection using a composite video cable

4.When the New Device Found screen displays, assign the name Camcorder.

5.Press EXIT to close the New Device Found screen.

6.Highlight the icon for the camera input and press

ENTER.

7.If viewing photos, advance through the images manually or set the camera to advance automati- cally.

8.If viewing photos, control the slideshow from the camera. Advance through the images manually or check if the camera can advance automatically.

Sleep Timer

The Sleep Timer turns the TV off after the length of time you set. To set the TV to turn on at a certain time of day, see the Setup > Timer menu on page 27.

Setting the Sleep Timer

1.Press SLEEP.

2.Press SLEEP additional times to increase the time in 30-minute increments up to the maximum of 120 minutes.

3.Press EXIT or wait five seconds without pressing any keys for the message to clear.

Viewing or Changing the Sleep Timer

1.Press SLEEP to display the on-screen message.

2.Press SLEEP additional times to change the time before the TV powers off. To cancel the Sleep Timer, press SLEEP repeatedly until OFF is dis- played.