Planar LC640.480.33-AC Installation and Handling, Mounting the Display, Mounting ECA Face Down

Page 6

Installation and Handling

Do not drop, bend, or flex the display. Do not allow objects to strike the surface of the display.

Mounting the Display

To maximize shock and vibration performance, the display must be properly mounted using all four mounting hole locations. There are two recommended mounting configurations as shown in Figure 1 using the hardware listed in Table 1 below. Appropriate changes to these mounting configurations may be needed to meet specific requirements or applications.

Figure 1. Mounting Options.

Display Face Down

ECA Face Down

Table 1. Mounting Hardware.

 

 

 

Screw

#6 SS, hex head or hex washer head, or M3 SS hex head

 

or hex washer head

 

Washer

Bearing washer for display face down bearing

 

application only Lockwasher, external type

Tightening torque

4 oz-in \ 2.8x105 dyne – cm

 

Mounting Display Face Down

Standoff spacers with a minimum height of 0.102" (2.59 mm) must be used at all four mounting locations to prevent binding and deflection of the display. Threaded studs anchored in a bezel would be a design variation of this mounting option.

Mounting ECA Face Down

When mounting the display with the mounting screws installed from the viewing side, it is not necessary to incorporate a flat washer. Provide for proper vent clearance and an air gap/isolation allowance of 0.197" (5 mm) or better as described below.

4 LC640.480.33-AC Operations Manual (OM600-01)

Image 6
Contents LC640.480.33-AC Date Description Contents Figures Features and Benefits LC640.480.33-AC DisplayMounting Display Face Down Installation and HandlingMounting the Display Mounting ECA Face DownCleaning Cable LengthAvoiding Image Retention Mechanical Characteristics SpecificationsEnvironmental Characteristics Environmental CharacteristicsOptical Characteristics Optical CharacteristicsSafety and EMI Reliability and Backlight LifeInterfacing and Operation Power RequirementsPower Sequencing LCD only Control BasicsBacklight Signals Backlight Signal DC CharacteristicsVideo Signal DC Characteristics Video SignalsVideo Signal Characteristics Video ModesSignal Timing Video signal timingVertical mode video signal timing Timing Diagram, 480-line mode Timing Diagram, 400-line mode Timing Diagram, 350-line mode Video Characteristics Video Data Color/Grayscale MapConnectors Pixel PositionVideo Connector J3 Video Connector J3 PinoutsDimming Connector J2 Pinouts Dimming Connector J2Backlight Power Connector J1 Backlight Power Connector J1 PinoutsResponse Times Optical FeaturesViewing Angle DimmingBacklight Dimming Modes Dimming Control InterfacingBacklight Dimming Modes Inverting the Display Inverting the DisplayTemperature Considerations Luminance Variation Due to Ambient TemperatureThermal Shutdown Display Dimensions Warm-up CharacteristicDisplay Dimensions Description of Warranty Support and ServiceOrdering Information OM600-01