Remote Control, TV Catv VCR DVD 169 Power Mode

TV CATV VCR DVD 16:9 POWER MODE

EZ SURF		PIP		ON/MOVE
EZ SURF	CHANNEL			ON/MOVE
INPUT SOURCE FREEZE				SWAP
DISPLAY		1	2	3
SLEEP TIMER		4	5	6
HYPER SUR.		7	8	9
VIDEO STATUS	100+		0 RETURN+
THEATER PRO BBE				LIGHT
RM-C325G
MUTING		+		V CHIP
		+
		CH
VOL			VOL
			+
		CH		EXIT
		CH
MENU				PIP OFF
VCR CHANNEL		VCR/DVD
PREV NEXT		POWER		TV/VCR
REW		PLAY		FF
REC		STOP	PAUSE
OPEN/CLOSE			STILL/PAUSE

Remote Control

Remote Control Basics

•Before you can operate the remote control, you must first install the batteries (included). See “Changing the Batteries” at the bottom of this page for instructions. (For an illustration, please see page 10.)

•Press the POWER button to turn the television on or off.

•Make sure the TV/CATV switch is set to TV. Move the switch to CATV only if you need to operate a cable box.

•Slide the VCR/DVD selector switch to VCR to control a VCR, slide to DVD to control a DVD player. Please see pages 20 to 22 for instructions on programming your remote control to operate a Cable box, VCR or DVD player.

•Press the CH+ and CH- buttons to scan through the chan- nels. Tap the CH+ or CH- button to move through the chan- nels one channel at a time.

•To move rapidly through the channels using JVC’s Hyperscan feature, press and hold CH+ or CH-. The chan- nels will zip by at a rate of five channels per second.

•Press VOL+ or VOL - to raise or lower the volume. An indica- tor bar will appear onscreen to show you the television vol- ume level.

•The CH+/- and VOL+/- buttons are also used to navigate JVC’s onscreen menu system.

•You can directly access specific channels using the 10-key pad.

•For more information on remote control button features, see pages 43 to 46. For information on using the onscreen menus, see page 24.

Notes: Remote control model RM-C325G is shown at the left. A different model remote control may have come with your television.

Changing the Batteries

Push down on the remote’s back cover and slide towards the bottom to remove it.

Insert two AA batteries (supplied), carefully noting the "+" and "–" markings on the batteries and on the remote control. To avoid a potential short circuit, insert the "–" end first. Be sure to use only size AA batteries.

When batteries are installed, slide the cover back into place (until it clicks into position).

•If the remote control acts erratically, replace the batteries. Typical battery life is six months to one year. We recommend using alkaline batteries for longer battery life.

When you change the batteries, try to complete the task within three minutes. If you take longer than three minutes, the remote control codes for your VCR, DVD, and/or Cable Box may have to be reset (see page 20-22).