SoundMax SM-CDM1042 instruction manual Loud ON/OFF

During AF search, PI stations and non-RDS (Radio Data Station) stations with strong signal will be masked, in the latter case, the non-RDS stations may cause interference, resulting the real AF to be masked due to the misjudgment of the radio under interference. Press VOL+/VOL- buttons to select the desired mode: MASK DPI and MASK ALL.

-MASK DPI: To mask only the AF with different PI.

MASK ALL: To mask both PI and strong signal non-RDS station.

￿￿TA VOL

Choose the TA volume level.

￿￿RETUNE mode

To determine the initial time of automatic TA (Traffic Announcement) search. There are 2

modes: RETUNE L and RETUNE L.

-RETUNE L: 90 seconds.

-RETUNE S: 30 seconds.

Note: Retune mode is active for TA SEEK mode only.

￿￿EQ MODE:

The car audio device is equipped with 4 preset equalization modes. After entering this mode select the EQ mode as follows: DSP OFF, DSP POP, DSP ROCK, DSP CLAS, DSP FLAT. When using preset EQ modes you will not have access to Bass and Treble settings.

￿￿LOUD ON/OFF:

Choose Loud ON or OFF.

￿￿CLOCK FORMAT:

Choose 12 of 24 hours mode

￿￿VOL LAST/ADJUST:

Choose between VOL LAST and VOL ADJ.

-VOL LAST: The unit switches on at the actual last volume level when it was last switched off.

VOL ADJ: you can pre-select a constant switch-on volume after entering into this mode. To set the volume to a certain level, press the SEL button momentarily when V-ADJ is displayed. Then

press VOL+/VOL- buttons to adjust to certain volume level.

￿￿BEEP mode

BEEP: the unit beeps only when any allowed double button is pressed longer than 1 sec.

BEEP ON: the unit beeps when any button is pressed.

15