JVC XV-521BK manual Using the remote control unit, To install batteries in the remote control unit

Page 18

Getting started

Using the remote control unit

Using the remote control, you can operate not only all the functions of the unit but also basic functions of your TV.

To install batteries in the remote control unit

The battery compartment is located on the back of the remote control unit.

1Press down on the point shown by the arrow at the top of the compartment cover, and pull up the cover to open the compartment.

2Place the two accessory R6P (SUM-3)/AA(15F) batteries in the remote control according to the polarity markings (“+” and “–”) inside the compartment and on the

batteries.

Getting

started

3Place the cover over the compartment, and press down lightly.

•The batteries will last about six months with normal use. If the functions of the remote control become erratic, replace the batteries. See below for more information.

Precautions for the safe use of batteries

Observe the following precautions for the safe use of batteries. If they are used improperly their life will be shortened, they may burst or their contents may leak.

Precaution

•Remove the batteries from the remote control if it is not going to be used for a long period of time.

•Remove dead batteries and dispose of them properly.

•Never leave dead batteries lying around, take them apart, mix them with other refuse, or throw them into an incinerator.

•Never touch liquid that has leaked out of a battery.

•Do not mix new and old batteries, or batteries of different types, when replacing them.

15

Image 18

Contents XV-521BK Mises en garde, précautions et indications diverses Table of contents Features Supplied accessoriesIntroduction To playback in random order Random Avoid high temperatures Installation of the unitPower cord When you’re awayPreliminary knowledge Names of parts and controlsFront panel Remote control unit Subtitle Digest buttonAudio Strobe button Audio Strobe button 24 Infrared signal-emitting windowSubtitle Digest button 23 Numeric buttons 10Display window Rear panelOpening displays Operational PrinciplesOn-screen displays Preference displaysPlay mode displays To prevent the monitor from burning out Screen SaverStatus displays How to use numeric buttons On-screen guide iconsDisc structure About discsPlayable disc types Playable discsBefore making any connections Getting startedConnections To connect to a TVVideo cable To connect to a TV with the component video input jacksTo connect to an audio amplifier or receiver SuppliedDigital equipment To connect the power cordTo connect to audio equipment with a digital input Red White Audio cablePrecautions for the safe use of batteries Using the remote control unitTo install batteries in the remote control unit PrecautionSetting the remote control signal for operating your TV To use the remote control unit for TV operationTo control the volume of a JVC’s amplifier or receiver Manufacturer code listInserting and removing discs Basic operationsTurning on/off the unit Press OPEN/CLOSE to close the disc trayTo stop playback completely Basic playbackTo start playback To stop playback temporarilyTo memorize the interrupted position To resume playbackTo locate the beginning of the scene or song To resume playbackPress Menu or Title Advanced operationsTo locate a desired scene from the DVD menu Use Cursor 2/3/5/to select a desired item, then press EnterTo locate a desired selection using the numeric buttons To locate a desired selection using 4 or ¢Press Enter Press Play Mode CancelUse Cursor 2/3 to move to CHAP. SEARCH, then press Enter Use Cursor 2/3 to move to Time SEARCH, then press EnterUse Cursor 2/3/5/to select the desired scene When you make a mistakePress Subtitle Digest while holding down Shift For DVD Video For Audio CDSpecial picture playback To display still pictures StrobePress Audio Strobe while holding down Press Slow To cancel strobe playTo playback in slow-motion Slow Press PAUSE, then use the Shuttle knobTo playback in the desired order Program Changing the playback orderTo zoom a scene Zoom Press Angle Zoom while holding downTo playback in random order Random Press Play to start program playUse Cursor 2/3 to move to Random To repeat the current selection or all disc contents Repeat Repeat playbackUnit locates a and starts repeat playback To repeat a desired part A-B RepeatTo A-B Repeat Between a and B For DVD Video For Audio CDSelecting a scene angle To select a scene angle from the normal screen AngleTo select a scene angle from the angle list display Angle To turn the subtitle on and off, press Changing the language and soundTo change the audio language or sound Audio Press Audio StrobeTo select the picture character Theater Position Selecting the picture characterEnjoying virtual surround sound Press 3D PhonicChecking the status To check the disc/time informationPress Display Time To check the DVD function statusPress Display Time while holding down To turn off the disc/time display Press DISPLAY-TIMESelecting preferences Initial settingsHow to set preferences LanguageAudio Display System On-screen guide will be displayedAuto standby function is off Points Country Code, use Limiting playback by childrenTo set Parental Lock for the first time Cursor 2/3 to select US for countryTo change the country code, use Cursor To temporarily release the Parental lockPress Enter while holding down Shift To change the set level, use Cursor 2/3toAV Compu Link remote control system Connection and setupAdditional information Care and handling of discs OperationTroubleshooting Symptom Possible case RemedySpecifications Appendix a Table of languages and their abbreviations Appendix B Country code list for parental lock 0700RIMUBNJSC