JVC XV-521BK manual Troubleshooting, Symptom Possible case Remedy

Page 46

Additional

information

 

 

Additional information

Troubleshooting

What appears to be a malfunction may not always be serious. Please go through the following list before requesting service.

Symptom

Possible case

Remedy

 

 

 

 

Power does not come on.

Power plug is not inserted securely.

Plug in securely.

 

 

 

 

Remote control does not work.

Too far from the unit.

More closer to the unit.

 

 

 

 

 

 

The tip of the remote unit is not

Point the infrared light- emitting window

 

 

pointed in the right direction.

toward the remote sensor on the front panel.

 

 

 

 

 

 

Batteries are exhausted.

Replace the batteries with new ones.

 

 

 

 

 

 

Battery polarity is incorrect.

Take out the batteries and insert them again

 

 

 

in the correct direction.

 

 

 

No picture is displayed on the

Connection of video cable is

Connect the cable correctly.

monitor.

incorrect.

 

 

 

 

 

 

 

Input selection of TV is incorrect.

Select correctly.

 

 

 

 

 

 

Disc is not playable.

Use a playable disc. (See page 11.)

 

 

 

Picture is noisy.

The unit is connected to a VCR

Connect the unit so that the picture signal

 

 

directly and the copyguard function

flows directly to the TV.

 

 

is activated.

 

 

 

 

No audio is reproduced.

Connection is incorrect.

Check the connections.

 

 

 

 

 

 

Input selection of amplifier is

Select correctly.

 

 

incorrect.

 

 

 

 

No audio is reproduced when

The audio signal is derived from the

Use the AUDIO OUT when playing back such

playing back a DVD disc recorded

unit's DIGITAL OUT.

discs.

with 96-kHz, linear PCM audio.

 

 

 

 

 

Sound is distorted or noise is

Disc is dirty.

Wipe the disc surface.

generated.

 

 

 

 

 

Picture does not fit the television

MONITOR TYPE is not correctly set.

Select monitor type correctly. (See page 37.)

screen.

 

 

Television is not correctly set.

Set the television correctly.

 

 

 

 

 

Operation is not possible.

Microcomputer malfunction due to

Turn off the power and unplug the power

 

 

lightning or static electricity.

cord, then connect the power cord again.

 

 

 

 

 

 

Moisture condensation caused by a

Turn off the power, then turn it on a few hours

 

 

sudden change of temperature or

later.

 

 

humidity.

 

 

 

 

 

43

Image 46
Contents XV-521BK Mises en garde, précautions et indications diverses Table of contents Supplied accessories FeaturesIntroduction To playback in random order Random Avoid high temperatures Installation of the unitPower cord When you’re awayNames of parts and controls Preliminary knowledgeFront panel Subtitle Digest button Remote control unitAudio Strobe button Audio Strobe button 24 Infrared signal-emitting windowSubtitle Digest button 23 Numeric buttons 10Display window Rear panelOpening displays Operational PrinciplesOn-screen displays Preference displaysTo prevent the monitor from burning out Screen Saver Play mode displaysStatus displays How to use numeric buttons On-screen guide iconsDisc structure About discsPlayable disc types Playable discsBefore making any connections Getting startedConnections To connect to a TVVideo cable To connect to a TV with the component video input jacksTo connect to an audio amplifier or receiver SuppliedDigital equipment To connect the power cordTo connect to audio equipment with a digital input Red White Audio cablePrecautions for the safe use of batteries Using the remote control unitTo install batteries in the remote control unit PrecautionSetting the remote control signal for operating your TV To use the remote control unit for TV operationTo control the volume of a JVC’s amplifier or receiver Manufacturer code listInserting and removing discs Basic operationsTurning on/off the unit Press OPEN/CLOSE to close the disc trayTo stop playback completely Basic playbackTo start playback To stop playback temporarilyTo memorize the interrupted position To resume playbackTo locate the beginning of the scene or song To resume playbackPress Menu or Title Advanced operationsTo locate a desired scene from the DVD menu Use Cursor 2/3/5/to select a desired item, then press EnterTo locate a desired selection using the numeric buttons To locate a desired selection using 4 or ¢Press Enter Press Play Mode CancelUse Cursor 2/3 to move to CHAP. SEARCH, then press Enter Use Cursor 2/3 to move to Time SEARCH, then press EnterUse Cursor 2/3/5/to select the desired scene When you make a mistakePress Subtitle Digest while holding down Shift For DVD Video For Audio CDTo display still pictures Strobe Special picture playbackPress Audio Strobe while holding down Press Slow To cancel strobe playTo playback in slow-motion Slow Press PAUSE, then use the Shuttle knobTo playback in the desired order Program Changing the playback orderTo zoom a scene Zoom Press Angle Zoom while holding downPress Play to start program play To playback in random order RandomUse Cursor 2/3 to move to Random To repeat the current selection or all disc contents Repeat Repeat playbackUnit locates a and starts repeat playback To repeat a desired part A-B RepeatTo A-B Repeat Between a and B For DVD Video For Audio CDTo select a scene angle from the normal screen Angle Selecting a scene angleTo select a scene angle from the angle list display Angle To turn the subtitle on and off, press Changing the language and soundTo change the audio language or sound Audio Press Audio StrobeTo select the picture character Theater Position Selecting the picture characterEnjoying virtual surround sound Press 3D PhonicChecking the status To check the disc/time informationPress Display Time To check the DVD function statusPress Display Time while holding down To turn off the disc/time display Press DISPLAY-TIMESelecting preferences Initial settingsHow to set preferences LanguageAudio Display On-screen guide will be displayed SystemAuto standby function is off Points Country Code, use Limiting playback by childrenTo set Parental Lock for the first time Cursor 2/3 to select US for countryTo change the country code, use Cursor To temporarily release the Parental lockPress Enter while holding down Shift To change the set level, use Cursor 2/3toConnection and setup AV Compu Link remote control systemAdditional information Care and handling of discs OperationTroubleshooting Symptom Possible case RemedySpecifications Appendix a Table of languages and their abbreviations Appendix B Country code list for parental lock 0700RIMUBNJSC