JVC XV-N316S About the scanning mode, Progressive scan video playback available, Picture Source

CConnecting to a TV with component jacks

For XV-N310B/XV-N312S/XV-N315B/

XV-N316S only

You can enjoy picture of high-quality color reproduction by connecting the COMPONENT VIDEO OUT jacks on the player to your TV.

NOTES

•Connect “Y” to “Y,” “PB” to “PB” (CB), “PR” to “PR” (CR) correctly.

•The video output jack, scart connector and component jacks cannot be used at the same time.

•If your TV has component video input jacks of BNC type, use an adapter which converts a pin jack to a BNC jack (not supplied).

About the scanning mode

Depending on the material source format, DVD VIDEO discs can be classified into two types; film source and video source (note that some DVD VIDEO discs contain both film source and video source).

When the player plays back a film source material, uninterlaced progressive output signals are created using the original information. When a video source material is played back, the player interleaves lines between the interlaced lines on each to create the interpolated picture and outputs as the progressive signal.

Progressive scan video playback available

In the progressive scanning mode, you can enjoy high quality picture with less flickers when the COMPONENT VIDEO OUT jacks are connected to a TV or monitor that supports the progressive video input.

Preparations

Blue

Component video cable (not supplied)

Y/C	RGB/COMPOSITE
COMPONENT
/COMPOSITE

Set the COMPONENT/ COMPOSITE - Y/C - RGB/ COMPOSITE selector to

“COMPONENT/COMPOSITE.”

Audio cable (not supplied)

Activating the Progressive scanning mode

Press and hold down VFP - I/P on the remote control unit for a few seconds.

When the scanning mode is set to the Progressive mode, the [P] indicator lights up in the display window.

Depending on the [PICTURE SOURCE] preference display and whether the current DVD VIDEO disc is film-source or video- source, the indicator that lights up in the display window differs, as shown in the table below.

Setting of	Source type of DVD VIDEO
[PICTURE SOURCE]	Film source	Video source
AUTO	[DDP]	[P]
FILM	[DDP]	[DDP]
VIDEO (NORMAL)/(ACTIVE)	[P]	[P]

Green	Y
	PB
	PR					TV
				IN
	IN
	White				VIDEO
					LE
Red					FT
					AUD
					IO
					R
					IG
					HT
			Red
	AV	OUT				The player
			Y
	VIDEO				PB
						PR
Green						COMPONENT
				O		DIGITAL	OUT
					T
					AUDIO
						C
						OAX
						IAL

Red

Blue

White

Red

NOTES

•The Progressive scanning mode works only when you connect the player’s COMPONENT VIDEO OUT jacks to your TV.

•There are some progressive TV and High-Definition TV sets that are not fully compatible with the player, resulting in the unnatural picture when playing back a DVD VIDEO disc in the Progressive scanning mode. In such a case, use the Interlaced scanning mode. To check the compatibility of your TV set, contact your local JVC customer service center.

•All JVC progressive TV and High-Definition TV sets are fully

compatible with the player (Example: AV-61S902).

6