Connections
How to connect the COMPONENT/RGB Input Terminals
Connections
How to connect the PC Input Terminals
Component signals (Y, PB, PR) connection
DVD Player
L
|
|
|
| AUDIO | |
|
|
| VD | HD PR/CR/R PB/CB/B Y/G | |
Audio |
| DVD (Y,PB, PR) OUT | R | ||
| COMPONENT/RGB IN | ||||
R OUT L | Y | PB | PR | ||
|
Y, PB, PR
COMPUTER
Conversion adapter (if necessary)
RGB
AUDIO
PC IN
3⋅ RCA video cables
AUDIO
2⋅ RCA audio cables
Audio input to L/R sockets
Notes:
(1)Change the
(2)Additional equipment and cables shown are not supplied with this set.
RGB signal (R, G, B, HD, VD) connection
PC cable
Audio
1/8" (3mm) stereo plug
Connect a cable which matches
the audio output terminal on the computer.
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and vertical |
scanning frequency of 48 to 120 Hz. (However, signals cannot be displayed if signals exceeding 1200 lines will not |
be displayed properly.) |
11
Example of input signal source | RGB input to |
| R, G, B, HD, VD sockets |
|
|
5⋅ BNC RGB cables
or
RGB camera
VD
L
AUDIO
VD | HD | PR/CR/R PB/CB/B | Y/G |
R
COMPONENT/RGB IN
(2) The display resolution is a maximum of 1024 ⋅ 768 dots when the aspect mode is set to “NORMAL”, and 1366 ⋅ 768 | |
| dots when the aspect mode is set to “FULL”. If the display resolution exceeds these maximums, it may not be |
| possible to show fine detail with sufficient clarity. |
(3) The PC input terminals are | |
| will need to make setting changes to the computer at the time of connection. |
(4) | Some PC models cannot be connected to the set. |
(5) | An adapter is required to use the PC cable |
(6) There is no need to use an adapter for computers with DOS/V compatible | |
(7) The computer shown in the illustration is for example purposes only. | |
(8) | Additional equipment and cables shown are not supplied with this set. |
(9) | Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified |
| frequency range. |
HD
AUDIO
2⋅ RCA audio cables
Audio input to L/R sockets
Notes:
(1)Change the
(2)Additional equipment and cables shown are not supplied with this set.
Signal Names for |
|
|
|
|
| |||||||
|
|
|
|
|
| Pin No. | Signal Name | Pin No. | Signal Name | Pin No. | Signal Name | |
| 11 |
| 12 13 14 15 | 1 | R | 6 | GND (Ground) | 11 | GND (Ground) | |||
6 | 7 | 8 | 9 |
| 10 | 2 | G | 7 | GND (Ground) | 12 | SDA | |
| 1 | 2 | 3 | 4 | 5 | |||||||
| 3 | B | 8 | GND (Ground) | 13 | HD/SYNC | ||||||
|
|
|
|
|
| |||||||
Pin layout for PC input | 4 | GND (Ground) | 9 | NC (not connected) | 14 | VD | ||||||
5 | GND (Ground) | 10 | GND (Ground) | 15 | SCL | |||||||
terminal |
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
1516