To connect an audio system, Monitor Display modes

Amplifier

Connections to other equipment

(continued)

To connect an audio system

This connection allows you to use an audio amplifier and external speakers, and adjust the audio level using the TV’s remote control.

To control the audio, turn on the TV and the stereo amplifier, and turn off the TV’s built-in speakers (see “Speakers” on page 20).

Rear of the unit

ENGLISH

To VAR AUDIO OUTTo Audio (L) Input To Audio (R) Input

NOTE:

Audio cord (not supplied)

To hear sound when using an external audio amplifier, the volume of both the TV and the amplifier must be set above 0 (zero).

For example, if the volume of the TV is set to 0, you will not be able to hear any sound, even if the volume of the amplifier is at its highest level.

To connect the TV/DVD to a camcorder, or a TV Game

To playback from a camcorder, connect the camcorder to the unit as shown.

This unit can also be used as a display device for many video games. However, due to the wide variety of signals generated by these devices and subsequent hook-up variations required, they have not all been included in the suggested connection diagrams.You’ll need to consult each component’s Owner’s Manual for additional information.

Rear of the unit

To VIDEO/AUDIO IN	To Audio/Video OUT
Audio/Video cord	or
(not supplied)

To connect the TV/DVD to a PC (Personal Computer)

Before you connect this TV/DVD to your PC, change the adjustment of your PC’s Resolution and Refresh rate (60 Hz).

Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the VGA connector PC MONITOR on the rear of the TV/DVD. Attach the connectors firmly with the screws on the plug. In case of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and to the AUDIO connector of the PC/DVI AUDIO IN jack of the TV/DVD.You can also connect the PC with HDMI cable. If you use HDMI cable, you don’t have to connect the audio cord. If you use DVI-to-HDMI cable, please connect audio cord as same way as VGA cable.

Press INPUT SELECT on the remote control to select PC mode.

Switch on the computer. The TV/DVD can operate as the computer monitor.

Rear of the unit	To PC
	MONITOR IN
	To PC/DVI
To	AUDIO IN	VGA cable
To	Audio cord	VGA cable
HDMI	Audio cord	(not supplied)
IN	(not supplied)
IN

HDMI cable (not supplied)

Monitor Display modes

MODE Resolution Refresh rate

VGA	640x480	60/ 72/ 75 Hz
VGA	720x400	70Hz
SVGA	800x600	56/ 60/ 72/ 75 Hz
XGA	1024x768	60/ 70/ 75 Hz
WXGA	1280x768	60Hz
WXGA	1360x768	60Hz

To return to normal mode Press INPUT SELECT again.

NOTE:
•	The on-screen displays will have a different appearance in PC mode than in TV mode.
•	If there is no video signal from the PC when the unit is in PC mode, “No signal” will appear on the TV-screen. 37