Step 6: Switching the TV ON/OFF
To switch the TV on
Your TV will switch on by two steps:
1- Connect the power supply cord to the sys- tem. Then the TV switches itself to stand- by mode and the power lamp becomes red located on the front of the TV.
2- To switch on the TV from
Press the “
” button on the remote con- trol or on the right side of the TV
or.
press a digit button on the remote control so that a programme number is selected,
or,
Press “
” or “
” buttons on the right side of the TV or on the remote control, so that last switched off programme is se- lected.
By either ways the TV will switch on and the power lamp will become green.
To switch the TV off
•Press the “
” button on the remote con- trol or on the right side of the TV, so the TV will switch to
NOTE: To switch the TV off completely re- move the mains plug from the socket.
Step 7: Initial settings
When the TV is first turned on, it goes into the initial settings mode. Follow the instruc- tions on the screen display to make the ini- tial settings.
Note: If the TV does not go into the initial settings mode this is because your TV has already been turned on for the first time. (Perform the initial settings with “INSTALLA- TION” (see page 25) in the DTV menu and “AUTO STORE” (Analogue) (see page 32) in the PROGRAM menu.)
Because this is the first time that IDTV has been used, there are no channels stored in the memory and below information will be displayed on the screen.
1.Press the [OK] button to start the auto- matic search.
The IDTV will automatically tune to the UHF transmission channels 21 to 68 looking for digital terrestrial TV broadcasts and display- ing the names of channels found. This pro- cess will take about five minutes. To cancel searching, you can press MENU button at any time during the process.
HINT: Depending on the reception conditions in your par- ticular area, you may find that the list of channels found includes one or more repeated names. This is because the receiver may detect and store some channels, including those it cannot receive clearly, from adjacent areas along- side the strong channels from a transmitter nearby. This is not a problem and the weaker channels can be deleted from the receiver later, as described in - Edit PR List on
page 23.
If no digital terrestrial television broadcasts are found, the receiver will display a mes- sage:
When “OK” button is pressed, following message will appear on the right bottom of the screen:
2.When the automatic search has fin- ished, the EDIT PR LIST menu appears.
•If you want to, you can now edit the programme numbers (PR) using the EDIT PR LIST function. For details, see “Edit PR List” on page 23.
•If you do not want to edit programme num- bers (PR), go to the next step.
3. Press the MENU button.
The EDIT PR LIST menu disappears and the following message appears.
- 14 -