JVC 0706TKH-MW-VPC Initial settings, Begin, Select a language, Select the teletext language group

Initial settings			After turning off the TV, it takes about 5 seconds to
			After turning on the TV, it takes about 1 minute to
			project the picture to its full brightness.
			make the screen dark. After that, cooling is performed
Set the menu language, installation location and automatically register the TV channels.			for about 1 minute.
			“About the LAMP indicator” (P. 6)
These channels can be edited later in “Editing channels” (P. 9).
	1	Begin			The remote control doesn’t
					work
			Shown only when powering on for the fi rst time.
				Confi rm the mode is set to “TV”.
			The power button on the remote control can also be
HD-Z70RF7	HD-Z61RF7
			used.
	HD-Z56RF7

When you press the Power button of the HD-Z61RF7 or HD-Z56RF7, recommend that press below of the button.

2	Select a language
	> Language	select
		set
3	Select the teletext language group
	> Teletext Language	select
	Group-1
	Group-2
	Group-3

Group-4

Group-5

For the teletext language group

“Language group for teletext” (P. 22)

If the characters are unreadable “Language group for teletext” (P. 22)

TV

To the previous screen

Exit

If the “JVC” logo does not appear or if you wish to make changes later

“Language”, “Teletext Language” and

“Auto Program” (P. 18)

MENU

BACK

4	Automatically register channels
	>> Auto Program
	CH 28
	14%

Check what was registered

5	> Edit				Edit channels
	PR	ID	CH/CC
	AV		CH	21
	01				in “Editing channels” (P. 9)
	02		CH	22
	03		CH	23
	04		CH	24
	05		CH	25

06CC 02

07CC 03

08CC 04

09CC 05

6 Confirm

8