JVC LT-42PM30 manual Remote Control, On Timer / Input / Sleep Timer

Remote Control

The following pages gives you a brief description of each button’s function. This remote can also control up to four other devices. See pages 51 - 52.

Allows you to set the TV to turn on and set the TV to turn off automatically after a set amount of time and channel of your choice.

On Timer / Input / Sleep Timer

Timer

On Timer	0 h	0 m
Input	0 - 0
Sleep Timer	0	min

TIMER

Notes:

• If you set the interval of On Timer by pressing the buttons, select channel at Input and press OK.

•After you set On Timer and turn off the TV, power lamp lights.

•You can check the remaining time of On Timer by displaying

this menu again.

• You can set the interval of Sleep Timer by pressing the  buttons.

•60 seconds before the TV turns off, a message will appear and it will count the remaining time.

•See page 50, “On Timer using iPod”.

		POWER
				Turns the TV on or off.
				Switch between “TV / STB / VCR / DVD / AUDIO devices.
MODE	TV	STB VCR	DVD AUDIO	See page 51.
				Switch between devices connected to Video-1, 2, 3, 4 and 5. For
				V4 (Video-4) and V5 (Video-5) you must select the signal input type
				first (ie. composite, S-Video, or component). To do so, you need
				to press the V4 or V5 button until the correct type is highlighted.
V1 V2		V3	V4 V5	Select “Composite 1” for composite video signal input, “S-Video”
				for S-video signal input, or “Component 1” for component video
				signal input. Select “Composite 2” for composite video signal input
				or “Component 2” for component video signal input. Select PC for
				PC signal input.
	1	2	3
	4	5	6	Change channels. Input remote codes. See page 51.
	7	8	9
		RETURN +
	TUNE	0	TV
				Lets you decide the input channel and select it. After pressing the
		TUNE		remote 0 - 9 buttons, press TUNE.

18