JVC LT-32JM30 manual Troubleshooting

Page 50

Troubleshooting

Refer to the table below to check the condition. If you think that there is a problem, contact the JVC Service Center where you purchased the television.

There is no power

See if the power cord became unplugged.

Check for a blown fuse or circuit breaker or a power outage.

There is no picture or sound

The antenna could be disconnected.

The tuner could be set improperly. See page 44.

The TV station may be having difficulties. Check to see if other stations are working.

Use the HDMI cable with HDMI logo.

If you have a device connected to INPUT-1, INPUT-2 or INPUT-3, you will not be able to hear any audio from the AUDIO OUT on the back of the TV.

You cannot output audio using the DIGITAL AUDIO OPTICAL OUT when you have digital sound from an HDMI device connected to the INPUT-1, INPUT-2 or INPUT-3 connection on the back of the TV.

This TV can accept 480i (Composite / S / HDMI / Component), 480p, 720p, 1080i and 1080p signals. Please check your settings.

Remote control is not operating properly or at all

Check to see that the batteries are still working and properly installed.

Make sure the remote has a clear sight path to the TV.

You may be too far from the TV. You must be within 23 feet (7 meters).

The power turns off by itself

Make sure the set did not become unplugged.

Perhaps the Auto Shut Off is set. See page 41.

Check to see if the Sleep Timer was set. See page 19.

It does not operate correctly

This television is operated by a microprocessor. It is possible that external noise or interference is causing the problem. If the television does not function correctly, remove the electrical plug from the wall outlet and wait a while before inserting it into the wall outlet again and operating the television.

The color quality is poor

Tint and Color may be improperly adjusted. See page 26.

The Video Status mode may be turned to the wrong setting. See page 26.

There are lines across the picture

There could be interference from another electrical appliance, such as a computer, another TV or VCR. Move any such appliances further away from the TV.

The picture is spotted

There could be interference from a high-wattage appliance, like a hairdryer or vacuum, operating nearby. Move the antenna away from the appliance or change to a coaxial cable connection which is less prone to interference.

There are double pictures (ghosts)

A building or passing airplane can reflect the original signal and produce a second, slightly delayed one. Adjust your antenna position.

50

Image 50
Contents Important Note Serial Number Model NumberDo not attempt to service the product yourself Risk of Electric Shock Do not OpenImportant Safety Instructions Important Safety Instructions FCC NoticeTable of Contents Key Features Full or Widescreen ModeLogos & Licenses Package Contents Caring for the frame and stand Caring for the ScreenPackage Contents Connect the stand Install your TVTidying the cables Disconnecting the stand Front Panel Photo Viewer ConnectorTV Basic Controls Side PanelTV Basic Controls Rear PanelHdmi Video AudioCompatible Signal Full / Regular / Slim / Panorama / Cinema / Full Native Remote ControlOn Timer / Input / Sleep Timer Basics Standard / Dynamic / Theater / Game Speech / Jazz / Classic / Rock / UserFAVORITE. Move Turn on the TV Set the language Initial SetupSet the mode Set time attributeThank you! Setup is now complete Set TV attributeDisplay the menu bar Display the desired menu Using the menusCustomizing Your TV Change or adjust the setting Close the menuVideo Status Color Management Video ResetColor Temp Dynamic GammaThumbnail View Video Input LabelPhoto Viewer Slide ShowInterval Aspect Type SettingClosed Caption Add Channel Tuner ModeAutoscan Chip When entering the passwordEdit Channel Set a new password When you lock or unlock channelsPassword Confirm and setGeneral Audience Sexual Content Strong LanguageNR Not Rated PG Parental Guidance SuggestedCan. Eng Can. FreGuide Reset Auto AdjustmentPhase Adjustment PC H-PositionSurround Audio ResetDigital Audio ML Sound StatusPower Power IndicatorLanguage Plug In MenuTime Zone Noise MuteAuto Demo Control with HdmiSystem Info Optical Out Connect an Antenna or Basic Cable Connect a Cable BoxConnect a VCR / DVD Player using Component Video Connect a VCR / DVD Player using Composite VideoConnect an Amplifier using the Digital Audio Optical OUT Connect an Amplifier or Home Theater SystemConnect a Digital Source Device Connect a CamcorderConnect a Blu-ray or Hdmi Device Connect a Computer Troubleshooting Picture is snowy image noise Picture is slightly cut off when you use 1080p format onlyNo signal or signal can not be displayed Screen is 80% blackSpecifications subject to change without notice SpecificationsPage Page Page Canada Digital Television Transition Notice