Common Interface, First Time Installation

Manual Search:

This is for searching for digital channels on a single broadcast frequency. The frequency channel number (21-68) is entered in the box at the top left of the screen and the re- ceived signal level and signal quality can be observed on the two bar graphs at the bot- tom. When OK is pressed, the TV searches that frequency and display a list of the chan- nels found.

Hint

The bar graphs of signal quality and signal level give a good indication of whether any channels are likely to be found. If only the signal level graph shows a high value then it is likely that an analogue channel occu- pies that broadcast frequency. If the signal quality bar is high as well then it is a digital frequency and digital channels will prob- ably be found.

Again, channels which duplicate those al- ready in the channel list are ignored. How- ever, the manual channel search will find all channels on the broadcast frequency.

When either search is finished, press the MENU key to return to normal broadcast viewing, to watch the new digital terrestrial television channels found.

First Time Installation:

To reset the TV, highlight the First Time In- stallation line in the menu and press OK. A warning screen is displayed in case of acci- dental operation.

Highlight the YES button with the “” or “” key and press OK to erase all the channels and settings and switch the receiver to standby.

Common Interface

It is required to subscribe to a pay channel company to view the pay channels of the Digital Terrestrial broadcasting.

Obtain the Conditional Access Module (CAM) and the Viewing card by subscribing to a pay channel company, then insert those to the Television using the following proce- dure.

1.Switch off the TV and unplug from the mains.

2.Insert the CAM, then Viewing Card to the slot that is located in the terminal cover at the left-hand side of the TV (from front view).

•The CAM should be correctly inserted, it is impossible to insert fully if reversed. The CAM or the TV terminal may be damaged if the CAM is forcefully inserted.

3.Connect the TV to the mains supply, switch on and then wait for few moments until the card is activated.

•Some CAMs may require the following set up. Please set the CAM by entering the DTV menu, Common Interface then pressing OK button. (CAM set up menu is not displayed when it is not required.)

•To see the viewing contract information, press MENU, Select DTV and Press OK, then Select Common Interface and press OK.

•When no module is inserted, “No CI Mod- ule” appears.

•Refer to the module instruction manual for details of the settings.

- 26 -