Kramer Electronics RC-6IR user manual Operating the RC-8IR, Commands Configuration

Using Your Universal Room Controller

5.1Operating the RC-8IR

In the following example1, that is illustrated in Figure 5, the RC-8IRis labeled with specific functions and each button is programmed2 to perform several tasks3 as defined in Table 4.

Each button may be assigned with up to 15 commands.

Table 4: The Commands Configuration

ON	OFF
DVD	Vol
	UP
PC	Vol
	DOWN
VCR	HELP
	DESK

Figure 5: RC-8IR Labels

Setup

The Label		The Macro Sequence
ON	￿￿	Power up the projector
	￿￿ Power up the power amplifier
	￿￿ Power up the DVD player
	￿￿ Power up the video player
	￿￿ Roll down the projector screen
	￿￿ Turn on the speakers
	￿￿ 1 minute delay [for the projector to heat up]
	￿￿	Turn lights off
	￿￿ The projector selects the PC input
OFF	￿￿	Turn lights on
	￿￿ Power down the projector
	￿￿ Power down the power amplifier
	￿￿ Stop the DVD player
	￿￿ Power down the DVD player
	￿￿ Stop the video player
	￿￿ Power down the video player
	￿￿ Roll up the projector screen
	￿￿ Turn off the speakers
DVD	￿￿	Stop the video player
	￿￿ The projector selects the DVD input
	￿￿	Play the DVD
VCR	￿￿	Stop the DVD
	￿￿ The projector selects the VCR input
	￿￿	Play the VCR
PC	￿￿	Stop the DVD
	￿￿	Stop the VCR
	￿￿ The projector selects a PC input
Vol UP	￿￿	Power amplifier volume up
Vol DOWN	￿￿	Power amplifier volume down
HELP DESK	￿￿	Call for technical assistance

1 This is only one example among numerous possibilities, each button can be configure as required 2 By the technical installer

3 A macro sequence, including up to 15 commands per button, carried out one after the other

8 KRAMER: SIMPLE CREATIVE TECHNOLOGY