Kramer Electronics FC-14 user manual Converting an RGBHV Source

Page 8
5.3 Converting an RGBHV Source

Using Your RGBHV to Component Transcoder

5.3 Converting an RGBHV Source

You can convert an RGBHV signal to Y, B-Y, R-Y, via a FC-14RGBHV to Component Transcoder, as the example in Figure 4 illustrates, as follows:

1.Connect the high resolution graphics source to the R, G, B, H/S and V BNC inputs.

2.Connect the Y, B-Y, and R-Y outputs to the plasma monitor.

3.Connect the 12V DC power adapter to the power socket and connect the adapter to the mains electricity.

4.Press the RGBHV input format selector.

The signal from the RGBHV high resolution graphics source converts and outputs to the plasma monitor.

5.Switch on the power.

The Power switch illuminates.

Figure 4: Converting from a High Resolution Graphics Source to a Plasma Monitor

6

KRAMER ELECTRONICS, LTD.

Page 7 Page 9
Image 8
Page 7 Page 9
Contents USER MANUAL ModelFC-14 RGBHV to Component TranscoderContents FiguresTables Contents1 Introduction 2 Getting Started3 Overview FC-14 RGBHV to Component Transcoder4 Your RGBHV to Component Transcoder 5 Using Your RGBHV to Component Transcoder Using Your RGBHV to Component TranscoderFeature POWER Switch5.1 Converting an RGB Source 5.2 Converting an RGBS Source Figure 3 Converting from an RGBS Workstation to a Plasma Monitor5.3 Converting an RGBHV Source 5.4 Converting a VGA Source Figure 5 Converting from a VGA Graphics Source to a Plasma MonitorTechnical Specifications 6 Technical SpecificationsTable 3 includes the technical specifications Only the first purchase customer may enforce this warranty P/N 2900-004017 REV Updates to this user manual may be found atE-mail info@kramerel.com
Top Page Image Contents