LG Electronics 3 owner manual Sending via a Wireless Network

			Using LG EzSign 3.0 Editor 17
Sending via a Wireless Network			ꔈꔈ New EzSign TV content will always replace
			existing content without a notification pop-up
Using a wireless network, you can send content			message.
			ꔈꔈ A password must be set for the router to
files saved on a PC to the TV without having to
			prevent other devices from being connected.
connect a USB device. To use this function, you
			1 Connect a wireless dongle to the TV that you
must first connect a wireless dongle to the TV in
order to connect to the wireless network. (See the			are connecting to the router. You can check the
Network Setting section.) The PC must also be			network connection status from the TV's network
connected to a router via a wired or wireless			menu. (The network must be connected to the
connection.			minimum gateway.)
		USB Wi-Fi Dongle	- For details on network connections, see page 19.
			2 Connect the PC to the router via a wireless/
			wired connection.
	PC Editor S/W
			3 In EzSign 3.0 Editor, select Send via Wireless
			Network.

4 Use the Refresh button to automatically scan for

	TVs connected to the router. You can also
	select Add TV to manually enter the IP address
Note	of a TV.
	5 Select a TV you want to connect and then select
ꔈꔈ The wireless dongle must be connected to the
	Send.
wireless dongle slot among the USB slots on
the TV.
ꔈꔈ If a content file is sent via the wireless dongle,
the file is immediately saved in the TV memory.
ꔈꔈ The connection may not be established
depending on wireless signal interference or
strength.

NOTE

ꔈꔈ If there is wireless signal interference, check whether the router is operating normally and connect it again. When there is a wall or anoth- er router between the router and the TV it may not work properly. Remove any obstacles before installing it.

ꔈꔈ When multiple TVs are connected to a single router, make sure that the router is working properly before setting a network.

6 When sending is complete, the sent content file is immediately played on TV.

NOTE

ꔈꔈ The first time the TV is shown on the list it is identified by its serial number.

You can give it a new name (up to 16 characters)

ꔈꔈ Wi-Fi connection is available only through an AP.

ꔈꔈ External Internet environments are not supported.

by clicking the TV name.