LG Electronics BP730N owner manual Initial Setup, Wheel

22		System Setting
Initial Setup			need to input the security code as necessary.
			If you have security on your access point, you
When you turn on the unit for the first time, the			6. Use w/s/a/dto select the IP mode
			between [Dynamic] and [Static].
initial setup wizard appears on the screen. Set the
			Normally, select [Dynamic] to allocate an IP
display language and network settings on the initial
			address automatically.
setup wizard.
1.	Press 1(POWER).
	The initial setup wizard appears on the screen.

2. Use w/s/a/dto select a display language and press Wheel ().

	7.	Select [Next] and press Wheel ( ) to apply
3	3. Try the some features of your Magic remote	network settings.
	control by following the guide on the screen.
System
Setting
		Network connection status is displayed on the
		screen.
	4. Read and prepare the preparations for the	For details on network settings, refer to
		“Connecting to your Home Network” on page
	network settings and then press Wheel ( )	17.

while [Start] is highlighted.	8. Check all the settings that you have set in the
	previous steps.

If wired network is connected, the network
connection setting will automatically be	Press Wheel ( ) while [Finish] is highlighted
finished.
	to finish the initial setup settings. If there is any
5. All available networks are displayed on the
	settings to be changed, use w/s/a/dto
screen. Use w/sto select [Wired Network]	select 1and press Wheel ( ).
or desired SSID of wireless network and press
Wheel ( ).