LG Electronics RU-52SZ53D owner manual Programming the Remote, Test your remote control

Programming the Remote

The remote control for your HD receiver is a multi-brand or universal remote control that can be programmed to operate most remote-control- lable devices of other manufacturers.

Note: The remote control may not be able to con- trol all models of other brands.

1	Test your remote control.
	To find out whether your remote control can
	operate the device without programming,
	turn on the device such as a the VCR and
	press the corresponding mode button (VCR)
	on the remote control while pointing at the
	device. Test the POWER and CH +/- buttons
	to see if the device responds properly. If
	not, the remote requires programming to
	operate the device.
2	Turn on the device to be programmed. Then
	press the corresponding mode button on the
	remote control.
3	Press the POWER button and the MUTE but-
	ton simultaneously. Now the remote control
	is ready to program the code for the corre-
	sponding device.
4	There are two ways to find the right code for
	the device.
	A. If you press the CH +/- buttons repeat-
	edly, the codes will change one at a time.
	Press the POWER button after each code
	change. If the right code is found, the
	device will turn off.
	B. Enter a code number using the number
	buttons on the remote. The right code num-
	bers for the corresponding component can
	be found on the following pages.
	Again, if the code is correct, the device will
	turn off.
5	Press the EXIT button to store the program.
6	Test the remote control functions to see if
	the device responds properly. If not, repeat
	from step 2.
P A G E	4 8

2

4

3

TV VCR CABLE DVD SAT

MODE LIGHT POWER

TV/VIDEO FRONT DVI

COMP1 COMP2 RGB

1 2 3

4 5 6

7 8 9

ENTER 0 FLASHBK

MUTESURF

SAPVIDEO

VOL CH

PIP PIPCH- PIPCH+ SWAP

RATIO CC FREEZE PIP INPUT

MENUEXIT

PLAY PAUSE STOP RECORD

REW FF

SKIP

3

4

5

Downloaded from www.Manualslib.com manuals search engine