Programming the Remote
Programming the Remote
GThe remote is a
Note that the remote may not control all models of other brands.
Programming a code into a remote mode
1.To find out whether your remote can operate the device without programming, turn on the device such as a VCR and press the corresponding device button on the remote.
After that, press the POWER button. If the device is turned off then it responds properly and the remote need not to be pro- grammed. If not, the remote should be programmed to operate the device. The programming procedures are explained below.
2.Press the MENU and MUTE button continuously at the same time for 2 seconds, the current selected device button will be illu- minated.
If you don't press any button for 20 seconds, the light on the device button will be turned off. In that case, you have to repeat from step 2.
4.Enter code numbers using the number button on the remote by refering the code table on the following pages. When pressing the button, the light blinks at a time. If the device turned off, the programming is successful.
5.Press the MENU button to store the code. After blinking twice, this code is stored.
6.Test the remote functions to see if the device responds properly. If not, repeat from step 2.
Owner’s Manual 93