LG Electronics 62DC1D, 56DC1D owner manual Programming the Remote

Programming the Remote

The Remote Control for your HD receiver is a multi-brand or universal Remote Control that can be programmed to operate most remote-controllable devices of other manufacturers.

Note: The Remote Control may not be able to control all models of other brands.

1. Test your Remote Control.

To find out whether your remote control can operate the device with out programming, turn on the device such as a the VCR and press the corresponding mode button (VCR) on the remote control while pointing at the device. Test the POWER and CH +/- buttons to see if the device responds properly. If not, the remote requires programming to operate the device.

2.Turn on the device to be programmed. Then press the cor responding mode button on the Remote Control.

3.Press the POWER button and the MUTE button simulta neously. Now the Remote Control is ready to program the code for the corresponding device.

4.There are two ways to find the right code for the device.

A. If you press the CH +/- buttons repeatedly, the codes will change one at a time. Press the POWER button after each code change. If the right code is found, the device will turn off.

2

4

3

TV	VCR CABLE DVD SAT
MODE	LIGHT	POWER
INPUT	TV INPUT	INFO

RGB-PC TIMER HDMI/DVI

1 2 3

4 5 6

7 8 9

0 FLASHBK

MUTEFAV

+

SAPADJUST

VOL - CH

3

4

B. Enter a code number using the number buttons on the Remote Control. The right code numbers for the corresponding compo- nent can be found on the following pages.

Again, if the code is correct, the device will turn off.

5.Press the EXIT button to store the program.

6.Test the Remote Control functions to see if the device responds properly. If not, repeat from step 2.

EZ SOUND SRS APM EZ PIC

RATIO CC FREEZE GUIDE

ENTER

MENUEXIT

5

Owner’s Manual 45