Contents, Quick Start | NEC LCD195WXM guide

Your new NEC MultiSync LCD monitor box* should contain the following:

¥MultiSync LCD monitor with tilt base

¥Audio Cable

¥Power Cord

¥Video Signal Cable (15-pin mini D-SUB male to 15-pin mini D-SUB male)

¥Video Signal Cable (DVI-D to DVI-D)

¥UserÕs Manual

¥CD-ROM

¥ Cable management cover

Cable management	CD-ROM
cover

UserÕs Manual Audio Cable	Power Cord	15-pin mini D-SUB	DVI-D to DVI-D
		male to 15-pin mini	MultiSync LCD monitor
		male to 15-pin mini
		D-SUB male

*Remember to save your original box and packing material to transport or ship the monitor.

Quick Start

To pull the stand, follow these instructions:

1.Place monitor face down on a non-abrasive surface (Figure 1).

2.Pull the stand holding the monitor with the other hand until the stand clicks (Figure 2).

NOTE: Handle with care when pulling the stand.

English

Figure 1

Figure 2

NOTE: Reverse this procedure if you need to re-pack the monitor.

To attach the MultiSync LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For the PC or MAC with DVI digital output: Connect the DVI-D signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system (Figure A.2). Tighten all screws.

For the Mac: Connect the MultiSync Macintosh cable adapter (not included) to the computer. Attach the 15-pin mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure A.3). Tighten all screws.

NOTE: Some Macintosh systems do not require a Macintosh cable adapter.

Macintosh Cable Adapter (not included)

Figure A.1

Figure A.2

Figure A.3

English-3