Remote Control
THE INSTRUCTIONS BELOW DESCRIBE THE FUNCTIONS ON THE REMOTE CONTROL.
1. | POWER | 17. | VOLUME UP / DOWN |
2. | NUMBER BUTTONS | 18. | REPEAT |
3. | SHUFFLE | 19. | |
4. | PROGRAM | 20. | MUTE |
5. | KODAK T.E. | 21. | GOTO |
6. | RESUME | 22. | CLEAR |
7. | SLOW | 23. | DISPLAY |
8. | STEP | 24. | I/P(INTERLACE/PROGRESSIVE SCAN) |
9. | SETUP | 25. | ZOOM |
10. | AUDIO | 26. | PAL/NTSC |
11. | MENU | 27. | ANGLE |
12. | DIRECTION BUTTONS | 28. | SUBTITLE |
13. | ENTER/PLAY | 29. | TITLE |
14. | PAUSE | 30. | STOP |
15. | SKIP FORWARD/ REVERSE | 31. | FAST FORWARD |
16. | OPEN/CLOSE | 32. | FAST REVERSE |
NOTICE:
•POWER button on the remote control is for standby power only. Turn on the main power button on the DVD Video Player.
•P/N button is for PAL/NTSC. If a PAL region 1 DVD disc is played, when the player is stopped completely, press P/N for normal playback. Otherwise, the picture will continuously roll.
•MUTE button cuts out sound from the player; MENU returns the player to the movie menu at the beginning of a disc; VOL controls player volume.
•When “
” displayed on TV, function is not operational on the disc.
To operate the DVD video player, you must first place the batteries in the remote control.
1.Open the cover.
2.Insert batteries (AA size).
Make sure to match the + and - on the batteries to the marks inside the battery compartment.
3.Close the cover.
1
2
3
4
5
6
7
8 
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
OPERATING WITH THE REMOTE CONTROL
Operating video player with the remote control.
The remote control must point at the remote sensor in order for the player to function correctly.
Distance: Maximum of 7 m from the front of the remote sensor.
3 0 3 0Angle: Approximately 30° from each direction.
*Do not place the remote sensor towards any light source such as direct sunlight. The DVD video player may malfunction.
BATTERIES
INCORRECT USE OF BATTERIES MIGHT CAUSE THEM TO LEAK, CORRODE OR EXPLODE.
•Do not place the batteries in the wrong direction.
•It is dangerous to charge/heat/open or
•Do not leave dead batteries or mix old/new batteries in the remote control.
•When not using the remote control for a long duration of time,
remove the batteries.When operating range becomes reduced, replace batteries.
•If battery leakage occurs, wipe the battery liquid from the battery compartment, then replace batteries.
REMOTE CONTROL
•The remote control should be aimed directly towards the remote sensor of the DVD video player.
5