System Setup
System Defaults
The final step of the installation is to establish the system’s defaults. It is helpful to take a few minutes to familiarize yourself with these settings, as they may require change before the first use and later from time to time.
Setup Menu
The first step in checking or changing the system defaults is to access the Setup menu. First, make certain that the DVD Player is properly connected. Turn the DVD Player on by first pressing the POWER button. For this process, however, you do not need to load a disc into the unit.
During Stop, Pause or Play mode, if you press the Setup button on the remote, the Setup menu appears on the screen.
SETUP MENU - - MAIN PAGE
GENERAL SETUP
AUDIO SETUP
VIDEO SETUP
PREFERENCE SETUP
EXIT SETUP
Navigating Menus
The remote’s Navigation (///) and ENTER buttons are used to navigate the menus and select specific settings. Use the (/) buttons to move the cursor to highlight the desired submenu, than press the button to enter the highlighted menu or
- 13 -
choose the highlighted content. The current setting is highlighted. If you wish to change this setting, use the (/) buttons to select a new setting and press the Enter button. Press the Navigation button to return to the left submenu column. Press the Play button or Setup button to exit the Setup menu.
Any new settings will be activated immediately.
After you press the SETUP button on the remote to enter the Setup menu, five submenus are shown: General setup, Audio setup, Video setup, and Preference setup. You may select EXIT SETUP with the Navigation buttons and press the ENTER button at any time to leave the Setup menu.