S T E P 1 - U N PA C K
Before you begin, make sure the following accessories are included in your DHT7100 packing case:
•Remote Control
•AM Loop Antenna
•FM Antenna
•Video cable
•User’s Guide
•Warranty Card
Insert two 1.5V AAA batteries.
Component
VideoVideo
S T E P 2 - I N S E R T R E M O T E
B AT T E R I E S
1.Remove the battery cover on the back of the remote by pressing down and sliding the cover in the direction of the arrow.
2.Insert two 1.5V AAA batteries, paying attention to the correct polarities (+ and
3.Replace the battery cover.
S T E P 3 - C O N N E C T V I D E O T O T V C o m p o s i t e V i d e o ( G o o d Q u a l i t y )
Connect the supplied video cable from the VIDEO OUT jack on the back panel of the system to the VIDEO IN jack on your television.
S - V i d e o ( B e t t e r Q u a l i t y )
If your television is equipped with an S- Video input, connect an
C o m p o n e n t V i d e o ( B e s t Q u a l i t y )
If your television is equipped with Compo- nent Video inputs, connect a component video cable (not supplied) from the Pr, Pb and Y jacks on the back panel of the system to the corresponding jacks on your televi- sion.
2 |