Hitachi 50HDA39 Operating the pre-coded function for your DVD player, Preparations

The Remote Control

The Remote Control

This remote is designed to operate different types of devices. You must first program the remote to match the remote system of your device. (refer page 21 for pre-codes)

Preparations;

1.Turn ON your device you want to operate.

2.Aim the remote control at the front of your device.

Operating the pre-coded function for your DVD player

1.To switch to DVD pre-coded mode, press and release the DVD button.

2.Hold down the DVD button on the remote and enter the two digit preset code that matches your DVD player, as shown on page 21. Release the DVD button.

3.Aim the remote at the DVD player and press the POWERbutton. The remote will turn off your DVD player when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player does not turn off, try a different two digit preset code.

4.The remote will now control your DVD player.

5.You will need to set the display type of your DVD player to 16:9 WIDESCREEN.

Operating the pre-coded function for your VCR

1.To switch to VCR pre-coded mode, press and release the VCR button.

2.Hold down the VCR button on the remote and enter the two digit preset code that matches your VCR, as shown on page 21. Release the VCR button.

3.Aim the remote at the VCR and press the POWERbutton. The remote will turn off your VCR when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off, try a different two digit preset code.

4.The remote will now control your VCR.

5.You will need to press the Record button twice to record.

Operating the pre-coded function for your cable box

1.To switch to Cable (CBL) pre-coded mode, press and release the CBL button.

2.Hold down the CBL button on the remote and enter the two digit preset code that matches your cable box, as shown on page 21. Release the CBL button.

3.Aim the remote at the cable box and press the POWERbutton. The remote will turn off your cable box when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off, try a different two digit preset code.

4.The remote will now control your Cable box.

Operating the pre-coded function for your set-top-box/satellite receiver

1.To switch to set-top-box/satellite (STB) pre-coded mode, press and release the SAT button.

2.Hold down the SAT button on the remote and enter the two digit preset code that matches your set-top-box/ satellite receiver, as shown on page 21. Release the SAT button.

3.Aim the remote at the set-top-box/satellite receiver and press the POWERbutton. The remote will turn off your set-top-box/satellite receiver when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your set-top-box/satellite receiver. If the set-top-box/satellite receiver does not turn off, try a different two digit preset code.

4.The remote will now control your set-top-box/satellite receiver.

Notes:

•If your device cannot be operated after performing the above procedures, your device code has not been pre- coded into the remote.

•In the unlikely event that your device cannot be operated after performing the above procedures, please consult your device operating guide.

•The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

•Refer to instruction manual of the device for operation of the buttons exclusively for the device.

20

3X80801A_En_p18-25 20 7/11/06, 8:07 PM