Hitachi 42PD8800TA, 55PD8800TA Function Size Switching, TV/AV signal input, Position Adjustment

42PD8800TA 55PD8800TA

FUNCTION (continued)

Size Switching

Each time button of the remote control is pressed, the screen display size is switched in sequence, and the status will be displayed at the bottom of the screen.

TV/AV signal input

ZOOM button

TV/AV1/AV2/AV3/AV4/AV5/HDMI1/HDMI2

4:3 Panoramic Zoom

Full Cinema

You can display the image at optimum condition by selecting display size depending on the current output image as shown below.

Current Output
	Image	Display Size			To display suitable screen as follows.
(Input Signal)
		4:3		Play a 4:3 image on screen faithfully. Blanking occurs on both sides.
		Panoramic		Play a 4:3 image which enlarges horizontal and vertical size of the
				middle in equal scales, and displays both sides appearing much wider.
(4:3 Signal)
		Zoom		Play a 16:9 image in 4:3 image (Vista size) faithfully.
				*In some case, slight blanking may remain at the top and bottom.
	(Vista)
		Cinema		Play a 21:9 image in 4:3 image (Cinema size) expanding vertically.
				*In some case, slight blanking may remain at the top and bottom.
	(Cinema)
		Full		Play a 4:3 image faithfully in the standard vertical size and
				horizontally squeezed.
(Squeeze)
Information						16
Aspect ratio represents horizontal : vertical ratio on screen.
							16(or 21)
For example, vista image is 16:9 in 4:3 image.
Position Adjustment					9	3		9
Vertical picture position can be adjusted for Panoramic, Zoom, and Cinema mode
as follows.
1. Press ▲▼buttons while operating the picture size display.
2. “Position” display will appear.						4
3. Adjust the position by ▲▼buttons.
Adjustment range of each picture size are as shown below.
	Panoramic:		-12 to+12		(The position cannot be adjusted in Panoramic 2 mode.)
	Zoom and Cinema:		-31 to+ 31

*When 1080i/60 component signal is received, it can be adjusted only 0 to +1.

ENGLISH

Position + 31

Press▲

Position - 31

Press▼

Vertical Size Adjustment at Panoramic Mode

While displaying a picture at Panoramic mode, the mode can be switched further between Panoramic 1 and Panoramic 2 with ◄ ►buttons on the remote control. By selecting Panoramic 2, the vertical size is scaled down so that you can see the whole image without blanking.

38

HITACHI

Downloaded From TV-Manual.com Manuals	2005/11/08 15:28:17
PW3-12th-P25-P39.indd 38