Hitachi 42PD6000TA user manual Operating Instructions, Turning Power On and Off, Indicating lamp

HITACHI MODEL 42PD6000TA

OPERATING INSTRUCTIONS

Indicating lamp

Remote-control receiver

Main power switch

•The main power switch is located at the back, on the right side.

Power button

POWER button

Turning Power On and Off

•To turn the PDP TV power ON, press the main power switch on the PDP TV main unit to ON, and then press the POWER button of control panel or the POWER button on the remote control.

•To turn the TV power OFF, press the POWER button of control panel or the POWER button on the remote control, and then press the main power switch on the PDP TV main unit to OFF.

•During normal use, the main power switch is set in the ON position, and the monitor can then be turned ON/OFF using the POWER button or the POWER button on the remote control.

Indicating lamp

Indicating Lamp	Power Status	Operating
Off	Off	When the main power
		switch is set to OFF.
	Off	When the main power
Lights Red		switch is ON, and the
	(Stand-by)
		POWER button is OFF.
	Off	When the main power
Lights Orange		switch is ON, and the
	(Power Save)
		power button is ON.
		When the main power
Lights Green	On	switch is ON, and the
		power button is ON.

When the indicating lamp lights in orange or the message “No Input Signal” or “Power Save” appears on the screen, there is something unusual about the status of reception. See “Power Save Mode” or “Symptoms That Seemingly Appear to be Failures.” 36 ~ 39

ATTENTION

•Avoid repeatedly turning the PDP TV on and off at short time intervals. Failures might result from such operation.

•Turn off the main power switch before leaving the PDP TV out of use for an extended period of time.

•If a power failure occurs while the main unit is running, it would be powered on upon recovery from the failure. Turn off the unit main power switch before leaving the main unit.

24