Hitachi P50T501, P42T501 Remote Control for Cable Box Functions, Precoded Cable BOX buttons

The Remote Control for Cable Box Functions

The Remote Control

OPERATING THE PRECODED FUNCTION FOR YOUR CABLE BOX.

This remote is designed to operate different types of cable boxes. You must first program the remote to

match the remote system of your cable box (refer to pages 37-38 for pre-codes).

1. Turn ON your cable box.

2. To switch to Cable (CBL) pre-coded mode, use the SOURCE SELECT button on the remote control to position the LED light to the corresponding selection SAT/CBL.

3.Hold down the SOURCE SELECT button on the remote and enter the four digit preset code that matches your cable box as shown on pages 37-38. Release the SOURCE SELECT button. The indicator light will flash 3 times if the code was accepted.

4.Aim the remote at the cable box and press the POWER button. The remote will turn off your cable box when the correct four digit preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off, try a different four digit preset code.

5.The remote will now control your Cable box.

NOTE: 1. If your cable box cannot be operated after performing the above procedures, your cable box code has not been precoded into the remote.

2.	In the unlikely event that your cable box
	cannot be operated after performing the
	above procedures, please consult your
	cable box operating guide.
3.	The remote control will remember the
	codes you have programmed until the
	batteries are removed from the

￿

￿

￿

￿

￿

￿

￿

￿

￿

￿

￿

￿

￿

￿

remote control. After replacing the

batteries repeat the entire programming

procedure as stated above.

￿PRECODED CABLE BOX buttons

These buttons transmit the chosen precoded cable codes :

-Power	-Cursor & Select	-Number PAD
-Menu	-Info	-Enter
-Exit	-Channel Up & Down
-Guide	-Last CH

￿EXCLUSIVE TV buttons

These buttons are for operating the TV :

-Day/Night	-CC	-Inputs (only if
-Aspect	-Vol Up & Down	programmed, refer
-PIP	-Mute	to page 36)
-Pause

MY CABLE BOX CODE IS:

NOTE: Refer to instruction manual of the Cable Box for operation of the buttons exclusively for the Cable Box.

32