Hitachi 28LD5200E specifications How to get to Adjustment mode

Page 6

28LD5200E (PW1L)

4.Adjustment

● How to get to Adjustment mode

Using the front control buttons with the set turned off (standby) can activate it.

Press the SUB-POWER() button, INPUT SELECT() button and button at the same time, and hold for more than 5 seconds.

The set turns on in adjustment mode with OSD.

● Changing data and Selecting Adjustment code

When the set is in adjustment mode, the cursor , , , and OK buttons of the remote control or front panel may be used as the adjustment keys.

, buttons are used for selecting adjustment code.

, buttons are used for changing data values.

OK button is used for confirming the data.

After finishing the necessary adjustment press MENU button. Adjustment mode is released and the set returns to normal condition.

● Memory Initialize operation

NOTE: The execution of this function returns the adjustment codes to the preset values, therefore, adjust- ment data will be lost.

Procedure

(1)Enter Adjustment Mode.

(2)Select MEMORY INIT adjustment code (No.704) and change the data value from 0 to 1.

(3)Activate MEMORY INIT by pressing OK button for more than 3 seconds.

(4)Select No.374 and change data value from 1 to 0.

(5)Check that the receiving channel goes to AV1. Unit is set to preset values.

6

Downloaded From TV-Manual.com Manuals

Image 6
Contents Service Warning Contents28LD5000TA PW1L Features PrecautionsSpecifications Applicable video signals for each input terminalComponent names CLE-958Adjustment How to get to Adjustment modeService adjustment items by I2C-bus control LPF SUB PWB Panel SGP Svid BELL/HPFLPF Main MAIN/SUBNJW1320OUT1GAIN Video PWB PWB PanelPDP-BLK ON/OFF NJW1320OUT2GAIN Video PWBSUB Contrast AV2 HD-PHASEDSUBAGC Inputmfe Main SUB Contrast AV3Color System CONTROL-MODE0BW, 23.58NTSC, 34.43NTSC Cmthreshold D15-D8Cmthreshold D7 -D0 NtscMCNRP6 NT2/NT3/NT4/PAL2/PAL3/PAL4 MYNRP8 HD1/HD4/HD5/HD6/HD7/HD8MCNRP5 MCNRP7CVECLP1 CVDSBG1CVDSBC1 CHHPF1EUYHECLPL3EP0 TimeoutAVC EUYHECLPL3EP1Expression of input signal mode format Factory ResetAutomatic Signal Level ADJ Ustment -RGB Color Temperature Adjustment -VIDEO Color Temperature Adjustment -PC Troubleshooting How to get to Burn-in modeHow to recover the remote and front key function Yes PWB? Signal circuit self-diagnosis function Self-Diagnosis FunctionUpdated Parts List For this Model is Available on Esta Block diagram Block diagram 1/2Block diagram 2/2 Connection diagram Wiring diagram Disassembly diagram     Hitachi Atago Building