Crown 1200, 2401, 2400, 601, 600 Choose Input Wire Connectors, Shows connector pin assignments for

Micro-Tech Series Power Amplifiers

3 Setup

3.4 Choose Input Wire

and Connectors

Crown recommends using pre-built or profes- sionally wired, balanced line (two-conductor plus shield), 22-24 gauge cables and connec- tors. Depending upon which amplifier input you choose, you should use either 3-pin male XLR connectors, TRS phone connectors, or terminal forks at the amplifier inputs.

Unbalanced lines may also be used but may result in noise over long cable runs.

The amplifier input connectors not used for audio signal input may be used to daisy-chain the audio signal to other components.

Figure 3.3 shows connector pin assignments for	Figure 3.3 Balanced Input	Figure 3.4 Unbalanced Input
	Connector Wiring	Connector Wiring
balanced wiring, and Figure 3.4 shows connec-
tor pin assignments for unbalanced wiring

NOTE: Custom wiring should only be performed by qualified personnel.

page 6 Operation Manual