Magnavox MDV455 owner manual Hookups cont’d

MDV455_17x 11/11/03 4:34 PM Page 10

10 Hookups (cont’d)

Connecting to a TV Only

TV has only a single Antenna In or RF-In jack

3			Back of TV
			(example only)
	Back of RF Modulator
		(example only)
	ANT IN TO TV VIDEO	AUDIO	IN
	IN	R	L

CH3 CH4

2

Antenna or Cable TV Signal		ANTENNA IN
		RF IN
1
	5	4

6

Before you begin, make sure you have an RF modulator and extra RF coaxial cables. These are not supplied with the Player, but are available from Magnavox or most consumer electronics retailers.

1	Connect the supplied video cable (which has yellow markings) to the Player’s yellow VIDEO jack.
	Connect the other end of the cable to the VIDEO IN jack on the RF modulator.The VIDEO IN
	jack on the RF modulator is usually yellow and might be labelled VIDEO, CVBS, COMPOSITE, or
	BASEBAND.
2	Connect the supplied audio cable (which has white and red markings) to the Player’s Audio L/R
	(left and right) jacks.
	Connect the other ends of the audio cable to the AUDIO IN jacks on the RF modulator. Audio
	jacks on the RF modulator usually are red (right) and white (left). Match the cable colors to the
	jack colors.
	You probably already have an Antenna or Cable TV signal connected to the ANTENNA IN jack
3 on your TV.
	Disconnect it now from the TV. Reconnect the Antenna or Cable TV signal to the ANTENNA IN
	jack on your RF modulator.
	Connect an RF coaxial cable (not supplied) to the RF OUT,ANTENNA OUT, or TO TV jack on
4 the RF modulator.The RF OUT jack may be labelled differently among different brands. Refer to
	the instructions provided with your RF modulator.
	Connect the other end of the same RF coaxial cable to the ANTENNA IN or RF IN jack on
	your Television.
5	Your RF Modulator should have a Channel 3/4 switch.The setting of this switch determines the
	TV channel on which you will watch materials playing on the DVD Player.
	Set the RF Modulator’s Channel 3/4 switch to either 3 or 4, whichever TV channel is least used
	in your area. If your RF modulator has a Modulator/Antenna switch, set it accordingly. Refer to
	the instructions that came with the RF Modulator.
	Turn on your TV and choose channel 3 or 4. Choose the same channel to which you set the RF
	Modulator’s Channel 3/4 switch.
6	Connect the Player’s power cord to a power outlet and turn on the DVD Player by pressing
	STANDBY-ON y on the front of the Player. If no Disc is in the Player, you should see the

Player’s screen saver on the TV screen.