Magnavox 26MF605W Series Antenna Connection, Basic Cable TV Connection, Connecting the Power Cord

Acombination antenna receives normal broadcast channels (VHF 2–13 and UHF

14–69). Your connection is easy because there is only one 75 Ω antenna jack on the back of your TV, and that’s where the antenna goes.

1If your antenna has a round cable

(75 Ω) on the end, then you’re ready to connect it to the LCD TV. If your antenna has flat, twin-lead wire (300Ω), you first need to attach the antenna wires to the screws on a 300-75Ω adapter(not supplied).

2Connect the antenna (or adapter) to the TV jack (marked 75 Ω) on the rear of the LCD TV. If the end of the antenna wire is threaded, screw it down finger tight.

ANTENNA CONNECTION

Outdoor or Indoor Antenna (Combination VHF/UHF)

2

HELPFUL HINT

Select weak signal mode via the smart picture settings in case your antenna connection is showing a lot of noise or strange patterns.

Twin-lead wire

to 300-75Ωadpter

or 1

Antenna with 75Ω cable

BASIC CABLE TV CONNECTION

our Cable TV signal into your home may
Ybe a single, 75 Ω cable. If so, this
connection is very simple. Follow the step
below to connect your Cable TV signal to	1
your new LCD TV.

1	Connect the cable TV signal to the TV
	jack (marked 75 Ω) on the rear of the	Rear Jack panel of Television
	LCD TV. Screw it down finger tight.

CONNECTING THE POWER CORD

Complete other connections prior to connecting the power cord.

1Connect the power cord to the AC IN connector of the LCD TV.

2Connect the other plug of the power cord to a wall outlet.

9

MAG-26_eng 0104.indd 9

The Cable TV singal from Cable Company 75Ω coaxial cable

Wall outlet

1/6/2005 10:30:37