Magnavox 26MF301B owner manual Primary MTS, Autoprogram, English, Channel List

Primary MTS

You can set the output mode as a default for the sound mode (NTSC only).

This setting is not interlocked when you change the output mode by pressing SAP. [Sound Functions] ➠ p.13

Use ▲/▼ to select the desired option, then press OK.

Stereo	Outputs stereo-audio.
Mono	Outputs mono-audio.
SAP	Outputs second audio program.

Setup

Before you begin:

Make sure the unit is connected to antenna or cable.

1 Use ▲/▼ to select the item you want to adjust, then press OK.

Picture	Autoprogram
Sound	Channel List
Setup	Add Channels
Features	Antenna
Language

2 Adjust the following items.

Autoprogram

If you switch wires (e.g. between antenna and CATV) or if you move the unit to a different area after the initial setting, or if you restore the DTV channels you deleted, it is recommended to use Autoprogram to perform a new channel search.

1 Use ▲/▼ to select [Autoprogram], then press OK.

2 Use ▲/▼ to select an appropriate option, then press OK.

Picture	Autoprogram will rescan all channels.		Back
Sound	Auto programming may take more than 20		Antenna
Setup	minutes to complete.		Cable
	Select your signal source.
Features
Language	Antenna
	Cable	Or
		ANT.IN

•When connected toVHF/UHF antenna, select [Antenna].

•When connected to CATV, select [Cable].

•[Autoprogram] will begin.

								English			17
											INTRODUCTION
		Please wait while the system is scanning for channels.
		Auto programming may take more than 20 minutes to complete.
	75%
		Digital channels						10 ch
		Analog channels						6 ch			PREPARATION
				MENU		Exit
• When the scanning and memorizing are completed, the
	lowest memorized channel will be displayed.
Note
• After setting [Autoprogram], using CH +/− on the remote control											WATCHING
skips unavailable programs automatically.
• If you are not receiving a signal from your cable service, contact
the Cable provider.
• If you press			or MENU during autoprogram, the setup of TV
channels will be canceled.											TV
• Even if [Autoprogram] is completed, the channel setting will be
lost if the AC power cord is unplugged before the unit goes into
standby mode by pressing					.						USING
• The PIN code will be required once you set a PIN code in the
[Child Lock].			➠ p.20
											FUNCTIONS
• If you want to change your PIN code, follow the instruction of
[Change PIN]. ➠ p.21
Channel List
											CONNECTING
The channels selected here can be skipped when selecting the
channels using CH + / −.
Those channels can still be selected with the Number buttons.
1 Use ▲/▼ to select [Channel List], then press OK.											DEVICES
2 Use ▲/▼ to select the channel you want to remove, then
press OK.											USEFUL
	Picture								DTV	11.1	TIPS
	Sound								DTV	11.2
	Setup			Highlight channels for					DTV	11.3
	Features
	Language			Ch Up / Down key selection.
											INFORMATION
					Ch Select		OK	Watch / Skip BACK		Back
• The channel display for the removed channel darkens.
	You will not be able to select the channel again using
	CH +/−.
• To reactivate a removed channel, use ▲/▼ and press
	OK.The registered channels are highlighted.
• When you remove a main channel, its subchannels are
	removed as well.

Note

•The channel with the [DTV] indicated on the display is ATSC. Otherwise the channel is NTSC.