Magnavox 19MF338B user manual Connect the AC power cord, Manage cables, Switch on the TV

ESPAÑOL FRANÇAISE ENGLISH

4.5Connect the AC power cord

BB WARNING:

Verify that your voltage corresponds with the voltage printed at the back of the TV. Do not insert the AC power cord if the voltage is different.

To connect the AC power cord

1.Locate the power connector at the back of the TV. The location of the power connector varies according to TV model.

2.Insert the AC power cord fully into the TV power connector.

3.Connect the AC power cord plug to the power outlet. Ensuring that the cord is tightly secured at both ends.

4.6Manage cables

Route your AC power cord, antenna cable and all other device cables through the cable holder at the back of the TV.The holder helps keep your cables tidy and easily manageable.

4.7Switch on the TV

Before you switch on the TV, check that the mains

cord is properly connected. Press POWER button at the front side of the TV, or press power the remote control. The TV normally takes 10-15 seconds to start up and the following screen appears the first time you turn on the TV.

Thank you for your purchase TV.

Please proceed with the following steps to set-up your TV. For the BEST possible picture performance, contact your local Cable / Satellite signal provider for High Definition signal options available in your area.

Next

Now press the GREEN Next button on your remote to proceed.

Follow the on-screen instructions to select your language and complete your TV setup. Installation takes approximately 10 minutes.

DD Note: If you connect your TV to a cable receiver box or satellite set-top box, you do not need

to install channels. Press the red button on the remote control to exit the channel installation stage of the setup.

EN-10