7.Change your TV installation
The first time you switch on your TV you select the language for the TV menus and make basic choices for picture and sound settings. Use this chapter to reinstall the TV, to set preferences in the TV menus, or to tune new TV channels.
7.1Select your menu language
1.Press MENU on the remote control and select Installation > Language.
Settings
| Installation | Language |
|
|
|
| Language | English |
| Autoprogram | Français |
| Source | Español |
| Clock |
|
| Current software info |
|
| Reset AV settings |
|
|
|
|
|
|
|
2.Select a language and press OK to confirm your choice.
3.Press 
to return to the Installation menu.
7.2Autoprogramming
This section describes how to search for and store channels automatically. Before you tune channels, ensure that you are registered with your cable TV provider and that your equipment is correctly connected.
1.Press MENU on the remote control and select
Installation > Autoprogram > Start Now.
Settings I Installation |
|
Autoprogram | Antenna |
Antenna |
|
Cable | Start now |
2. Select Cable or Antenna and press . |
| |
• When Antenna is selected, the TV detects | ENGLISH | |
antenna signals. It searches for NTSC and | ||
ATSC channels available in your area. |
| |
• When Cable is selected, the TV detects |
| |
signals supplied by cable. It searches for |
| |
NTSC, ATSC, and QAM modulated channels |
| |
available in your area. | FRANÇAISE | |
3. Press OK to start the installation. | ||
If you run Autoprogram when you have locked |
| |
channels, a message appears asking to enter your |
| |
PIN code. Enter your PIN code in order to |
| |
complete the installation. |
| |
If you have forgotten your PIN, reset it as | ESPAÑOL | |
described in Set or change your PIN on page 18. | ||
| ||
When autoprogramming is complete, |
| |
this message appears “Channel search |
| |
completed”. |
| |
4. Follow the |
| |
the installation. |
|
7.3Return your settings to default values
This section describes how to return picture and sound settings to their default values. The channel installation settings are not affected.
1.Press MENU on the remote control and select Installation > Reset AV settings.
Settings
| Installation |
| Reset AV settings |
|
|
|
|
| Language |
|
|
| Autoprogram |
| Start now |
| Source |
|
|
| Clock |
|
|
| Current software info |
|
|
| Reset AV settings |
|
|
|
|
|
|
|
|
|
|
2. Press 
to highlight Start now, and press OK to reset the AV settings.
3.Press Menu to exit.