Magnavox 39MF412B, 50MF412B owner manual Initial setup, Language 27, Location 27

These operations are accessible by remote control.

Some may also be accessible by control panel on the main unit.

Initial setup

This section will guide you through the unit’s initial setting which includes selecting a language for your on-screen menu and autoprogram, which automatically scans and memorizes viewable channels.

Before you begin:

Make sure the unit is connected to antenna or cable.

1 After making all the necessary connections, press to Turn On the unit.

• It may take a few moments to Turn On the unit for the first time.

• Initial setup menu appears automatically after the unit is Turned On.

2 Use ▲▼ to select the on-screen language from the choices (English / Español / Français) on the right side of the TV screen, then press OK.

3 Use ▲▼ to select Antenna for TV channels or Cable for CATV channels, then press OK.

Initial setup

Make sure the antenna is connected to ‘’ANTENNA IN’’ jack.				Antenna
Select your signal source.				Cable
Antenna				Skip
Cable	Or
		ANTENNA IN
Select	OK		Back	Skip

––When Antenna is selected, the TV detects antenna signals. It searches for DTV and Analog TV channels available in your area.

––When Cable is selected, theTV detects signals supplied by cable. It searches for DTV,AnalogTV and Cable channels available in your area.

•Autoprogram will begin.

Initial setup

Please wait while the system is scanning for channels. Auto programming may take more than 20 minutes to complete.

0%

Digital channels	0 ch
Analog channels	0 ch
	Skip

13

4Use ▲▼ to select the desired location setting, then press OK.

Initial setup

	Retail
Location Home is recommended for normal home use.	Home
In the Retail Store mode, all settings are fixed.

Select OK

•Select Retail, the unit will be set up with predefined setting for retail displays.

•Select Home, the unit is set to maximize the energy efficiency for home setting and it can be adjusted through a choice of picture and sound quality according to your preference. Use this setting to remove the E-sticker if visible from the display. ➠ p. 27

•When the initial setup is completed, the lowest memorized channel with the confirmation message of the location setting will be displayed on the TV screen.

•You must set Home in step 4. Otherwise, Picture and Sound settings you adjusted will not be memorized after the unit goes into Standby mode.

Note

••If you are not receiving a signal from your cable service, contact the Cable provider.

••If you press or MENU during autoprogram, this setup of TV channels will be canceled.

••The initial autoprogram function can be executed for either Antenna or Cable only once.When you change the connection (Antenna / Cable), set Autoprogram again.

➠ p. 20

••If there is no signal Input from the antenna terminal and no operation for several seconds after you Turn On the unit, helpful hints appears. Follow the instructions listed on the TV screen.

Initial setup

No channel is registered.			Retry
Try Autoprogram again?			Later
Verify that you have a cable connected to the “ANTENNA IN” jack
on the back of the TV, the channel installation process
searches this connection. If you are using a cable or satellite
box, please confirm the input which you have connected to
the box and press “SOURCE” key on the remote control to
select the appropriate source input.
Select	OK	Skip

After an initial setup is completed...

• If you want to scan the channels automatically again.

Autoprogram ➠ p. 20

• You can add the desired cable and Analog channels unmemorized by autoprogram.

	Add channels	➠ p. 21
•	If you want to change to another language.
	Language	➠ p. 27
•	If you want to change the location setting.
	Location	➠ p. 27

English