•When the scanning and memorizing are completed, the lowest memorized channel will be displayed.
Autoprogram
Please wait while the system is scanning for channels. Auto programming may take more than 20 minutes to complete.
75%
Digital channels | 10 ch |
| |
Analog channels | 6 ch |
| |
|
|
Exit
Note
••After setting Autoprogram, using CH + / − skips unavailable programs automatically.
••If you are not receiving a signal from your cable service, contact the Cable provider.
••If you press 
or MENU during autoprogram, the setup of TV channels will be canceled.
••Even if Autoprogram is completed, the channel setting will be lost if the AC power cord is unplugged before the unit goes into Standby mode by pressing 
.
••The PIN Code will be required once you set a PIN code in the Child and ratings lock.
➠ p. 23
••If you want to change your PIN code, follow the instruction of Change PIN. ➠ p. 25
Channel list
The channels selected here can be skipped when selecting the channels using CH + / −.
Those channels can still be selected with the NUMBER buttons.
1 Use ▲▼ to select Channel list, then press OK.
2 Use ▲▼ to select the channel you want to remove, then press OK.
Picture |
|
| DTV | 11.1 |
Sound | Highlight channels for |
| DTV | 11.2 |
Setup | Ch Up / Down key selection. | DTV | 11.3 | |
|
| |||
Features |
|
|
|
|
Language |
|
|
|
|
USB |
|
|
|
|
| Ch Select | Watch / Skip | Back |
|
•The channel display for the removed channel darkens.You will not be able to select the channel again using CH + / −.
•To reactivate a removed channel, use ▲▼ and press OK.The registered channels are highlighted.
•When you remove a main channel, its subchannels are removed as well.
Note
21 English
Add channels
This function lets you add the off the air Analog TV or Analog Cable channels that were not added by the autoprogram due to reception conditions during the initial setting.
1 Use ▲▼ to select Add channels, then press OK.
2 Use the NUMBER buttons to enter the number of the channel you want to add, then press OK.
| Picture |
| Add channels |
| Sound | For analog channels, select a |
|
| Setup | channel to be added using |
|
| number keys. |
| |
| Features | For digital channels, you must |
|
| perform Autoprogram function. |
| |
| Language | |
|
| USB |
|
|
|
| Ch Change | Back |
|
|
|
|
|
|
|
|
Note
••If setup completes successfully, Added to the channel list. is displayed.
••If external Input is used, it is not possible to register the channel and Unavailable will be displayed on the TV screen.
••Some channels cannot be selected by CH + / −. Use the NUMBER buttons to select the memorised channels.
Antenna confirmation
Digital TV operation
This function lets you check the Digital signal strength of each channel.
1 Use ▲▼ to select Antenna, then press OK.
2 Use the NUMBER buttons or CH + / − to select the channel for which you want to check the Digital signal strength.
Picture |
|
|
| Back | |
Sound |
|
|
|
| |
Setup |
|
|
|
| |
Features | Current | 50 | Max | 50 | |
Language | |||||
|
|
|
| ||
USB |
|
|
|
| |
|
|
|
| Ch Change |
Note
••If the channel is set to Analog channel or external Input, you cannot confirm the antenna condition.
••The channel with DTV indicated on the display is ATSC. Otherwise the channel is Analog TV.