Magnavox 51MP6200D Connect Accessory Devices, Set Top Box to TV, DVD Player or DVD Recorder to TV

Connect Accessory Devices

1 Set Top Box to TV	Using HDMI
	A	Connect RF cable from wall to input at back of the cable box.
		Set output switch on set-top box to CH 3 or 4 and tune TV to same
		channel.
	In some cases, cable box will automatically tune to channel 3 or 4. Just change channels
	until picture appears.
	B Connect cable box to TV using HDMI cable.
	Note: If the accessory device has DVI output only, use a DVI to HDMI adapter cable to
	connect to the HDMI connector. You need to also connect the audio cable to L and R
	AUDIO jacks. Next, go to Menu=>Setup=>Source=>Analog Audio In=> and
	select HDMI.
	Using RF Cable
	A	Connect RF cable from wall to input at the back of the cable box.
	B Use second RF cable to connect the cable box to the TV's antenna input.
	This connection gives mono sound. For stereo sound use also composite
	audio/video connection (Refer to panel 3).

	DVD Player or DVD Recorder to TV
2
		Using HDMI
		A	Connect DVD player/DVD recorder to the TV using HDMI cable.
		B	Turn on TV and DVD Player/DVD recorder. Press CH+ or CH- on remote
			control to tune to the video supplied by HDMI.
			Insert a prerecorded DVD into DVD player/DVD recorder and press PLAY
			to verify correct connection.

C

3	DVD Player or DVD Recorder to TV	Using Composite Video Input (YPbPr)
		A	Insert Component Video connectors into their corresponding jacks on both
			DVD player/DVD recorder and TV (Y, Pb and Pr).
		B	Connect red/white audio cables into the audio output jacks on DVD player/
			DVD recorder and audio AV inputs on TV.
		C	Turn on TV and DVD player/DVD recorder. Press AV on remote control
			until the connected source appears on TV screen.
			Insert a pre-recorded DVD into DVD player/DVD recorder and press PLAY to verify
			correct connection.

21